Abstract:This article presents a modified transmit/receive (T/R) front-end module (FEM) architecture with improved transmitter (TX) efficiency. Single-pole double-throw (SPDT) switch is commonly adopted in conventional FEM for T/R isolation, but its insertion loss (IL) deteriorates TX efficiency greatly. To alleviate this problem, a post-matching (PM) architecture is proposed to eliminate the switch in the TX branch. Specifically, a PM network (PMN) is employed to transform 50- $\Omega $ impedance at the antenna port into the intrinsic optimal load impedance of the power amplifier (PA), while the output capacitance of the PA is absorbed into a $\uplambda$ /4-transmission-line (TL)-based single-pole single-throw (SPST) switch in the receiver (RX) branch. The drain voltage of the PA can also be supplied via the SPST, avoiding the use of an additional choke inductor. The theoretical performance of the T/R switch, including bandwidth, IL, and isolation, is analyzed in depth. A 4.9–7.1-GHz FEM for Wi-Fi 7 application is implemented in a commercial 0.15- $\mu$ m gallium nitride (GaN)-high-electron-mobility transistor (HEMT) process to validate the proposed architecture, and the chip size is only 2 $\times$ 1.6 mm. The TX mode realizes a saturated power of 37.1–38.6 dBm and a saturated power-added efficiency (PAE) of 45%–52.4%. With MCS9 EHT160 signals, an average PAE of 18.5%–23.3% at an average power of 28–29.9 dBm is measured, while the error vector magnitude (EVM) specification of $-$ 32 dB is met. When digital predistortion (DPD) is applied, MCS13 EHT320 signals are also supported. The RX mode achieves a gain of 9.1–12.1 dB, a noise figure (NF) of 1.6–1.9 dB, and an input-referred third-order intercept point (IIP3) of 20.2–25.4 dBm.

A 4.8-6.4-GHz GaN MMIC Front-End Module with Enhanced Back-off Efficiency and Compact Size

A 4.9–7.1-GHz High-Efficiency Post-Matching GaN Front-End Module for Wi-Fi 7 Application

A 30Mhz-3Ghz 1W Stacked-Fet GaAs MMIC Power Amplifier.

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

A Fully Integrated C-Band GaN MMIC Doherty Power Amplifier with High Efficiency and Compact Size for 5G Application

An X-band GaN HEMT High-Efficiency Switchless Class-G Power Amplifier

A 24.3-to-44.8 GHz Reconfigurable Dual-Band T/R Front-End with an Implicit Switch-based Antenna Interface Supporting 600msym/s 64QAM

A 24.25-27.5 GHz Front-End Module with Transformer-Based T/R Switch for 5-G Communications

Design and Analysis of a 28 GHz T/R Front-End Module in 22-nm FD-SOI CMOS Technology

A Fully Integrated 47.6% Fractional Bandwidth GaN MMIC Distributed Efficient Power Amplifier with Modified Input Matching and Power Splitting Network

A 3.3-V Ku-Band Front-End Module with 2.6-Db NF and 18.9-Dbm OP1dB in 65-Nm CMOS

A W-Band GaN MMIC Single-Chip T/R Front End

A 1.8–5.4-GHz GaN MMIC Distributed Efficient Power Amplifier With Reactance Compensation and Adaptive Biasing

An Ultra-compact Bidirectional Ka-Band Front-End Module with 4.0-dB NF and 13.5-dBm OP1dB

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Reuse and 0.3–2.1-Ghz Baseband in 28-Nm CMOS Technology

A 700-2800Mhz Switchless Class-G Power Amplifier with Two-Quadrant Modulation for Back-off Efficiency Improvement

A Dual-Band GaN MMIC Power Amplifier with Hybrid Operating Modes for 5G Application

Modified elliptic response bandpass filtering integrated high‐efficiency GaN MMIC power amplifier at 24–28 GHz

A 24-28 GHz Power and Area Efficient 4-Element Phased-Array Transceiver Front-End with 21.1%/16.6%transmitter Peak/OP1dB PAE Supporting 2.4 Gb/s in 256-QAM for 5-G Communications

Design of a Ka-Band Single-Chip Front-End based on a 100 nm GaN-on-Si technology