Abstract:This paper presents a study of ethanol jet spray flame characteristics in a hot-diluted oxidant with different co-flow oxygen concentrations and fuel/air mass flow rate ratios (M-F/M-A ratios) through advance image processing technique. An air blast atomizer was located in a McKenna burner which was utilized to provide stable combustion surroundings and variable combustion atmosphere for ethanol jet spray. The co-flow oxygen concentrations were set to 5%, 10%, 15% and 21% (by volume) by adjusting the mass flow rates of CH4, O-2 and N-2. The M-F/M-A ratios were set to 0.245, 0.490, 0.735, and 0.980 by adjusting the fuel mass flow rate and the carrier air mass flow rate. A high-speed RGB CCD camera was employed to capture spray flame images continuously. Spray flame edge is detected using an auto-adaptive edge-detection algorithm which could detect the spray flame edge continuously and clearly. A flame zone is defined as the region surrounded by the detected flame edge to obtain flame parameters. Spray flame characteristics are described using the measured flame parameters, involving flame area, length, brightness, nonuniformity and temperature which are derived from the spray flame images. Spray flame area, length, brightness and nonuniformity are extracted through image processing technique directly. Moreover, two-dimensional (2D) temperature profiling of spray flame is obtained by coupling image processing technique with two-color pyrometry based on Planck's radiation law. The effects of co-flow oxygen concentration and M-F/M-A ratio on spray flame characteristics are investigated in this work. The spray flame parameters are observed to be sensitive to both co-flow oxygen concentration and M-F/M-A ratio. The results show that the fuel mass flow rate (M-F) has opposite effects on spray flame characteristics compared with the carrier air mass flow rate (M-A) in hot-diluted oxidant. Spray flame area and length are shown to decrease for higher co-flow oxygen concentrations, while spray flame brightness, uniformity and temperature are observed to increase for higher co-flow oxygen concentrations, owing to the enhancement of the combustion rate. A higher M-F/M-A ratio leads to higher spray flame area, length, brightness, uniformity and temperature, due to the increase of the droplet residence time or droplet concentration in hot-diluted oxidant. In the same M-F/M-A ratio, spray flame area and length are found to be smaller at a higher fuel flow rate (or carrier air flow rate). However, spray flame brightness, uniformity and temperature are demonstrated to be enhanced at a higher fuel flow rate (or carrier air flow rate). (CSPE)

Experimental Investigation on the Electrospray Counterflow Flame in a Small Combustor with a Porous Media As the Grounding Electrode

Spray Swirling Flame Dynamic under Combined Modulation of Air and Fuel

Experimental Investigation of the Flame Front Propagation Characteristic During Light-round Ignition in an Annular Combustor

Extinction in Non-Premixed Ethanol Spray Flames Using Direct Numerical Simulation

Experimental Study Of Spray Flame Characteristics In Hot-Diluted Oxidant Through Advanced Image Processing Technique

Spray flames in an air-heptane swirling combustor

Studies on a Swirling Heptane Spray Flame by Large-Eddy Simulation

Experimental study on ethanol spray combustion characteristics under oxy-fuel conditions

Combustion Instability and Emission Characteristics of Spray Flame under Flue Gas Jet

Experimental investigation on spark ignition and flame propagation of swirling kerosene spray flames

Direct Numerical Simulations and Analysis of Three-Dimensional N-Heptane Spray Flames in a Model Swirl Combustor

Computational Study of the Effect of Dual Air Swirling Injection on Turbulent Combustion of Kerosene–Air at a High Pressure

Experiment Study on Major and Intermediate Species of Ethanol/N-Heptane Premixed Flames

Experimental Investigation on the Symmetry and Stabilization of Ethanol Spray Swirling Flames Utilizing Simultaneous PIV/OH-PLIF Measurements

Experimental investigation of flow field features and spark ignition process in a multi-swirl airblast injector

Forced ignition and oscillating flame propagation in fine ethanol sprays

Experimental investigation on the combustion characteristics and thermoacoustic instability of liquid spray flame with blended fuel

Experimental Study on the Unsteady Spray Combustion Process of a Liquid Oxygen/Methane Swirl Coaxial Injector

Large-eddy Simulation Investigation on the Effects of Inlet Swirl/reynolds Number and Fuel Heating Value on a Turbulent Kerosene Spray Flame

Experimental Study on the Combustion Characteristics of Ultralow-Concentration Methane in Divergent Porous Media Burner

Large-eddy Simulation of Ethanol Spray-Air Combustion and Its Experimental Validation