Abstract:Recently, with the decrease in the quality of manganese resources, the efficient use of low-quality manganese ore resources has attracted widespread attention. At present, pyrite is often used as reducing agent to recover Mn(IV) in industrialization. However, the passivation of pyrite in the leaching reaction process will lead to a decreased reaction efficiency. Hence, in this study, microwave heating was applied in the reduction system in order to remove the inhibition of the passivation layer and accelerate the dissolution of pyrite, indicating an improvement in the corresponding Mn(IV) reduction efficiency. The results show that the leaching rate assisted by microwave heating was 95.07%, approximately 20% higher than that of conventional heating (75.08%), and the amount of sulfuric acid and pyrite was reduced by 14% and 20%, respectively. XPS analysis shows that there was an obvious sulfur elemental peak at 164.3 eV under traditional heating conditions, but it was absent when microwave heating was applied, and the elemental sulfur under conventional heating is 11.63%, which is higher than that under microwave heating (4.80%). Through scanning electron microscopy, it was noted that there are a large number of voids on the mineral surface under microwave heating, which can increase the solid-liquid contact area, effectively reducing the formation of the sulfur passivation layer and accelerating the dissolution of Mn (IV). In addition, the measurement of the dielectric constant of the solution mixture shows that the dielectric constant of the solution with mineral addition was increased from 36.533 (F/M) to 37.717 (F/M) and the loss tangent angle was increased from 8.61 × 10−3 to 9.21 × 10−3. It can be inferred that microwaves act directly on the mineral itself through the solution. Thus, the application of pyrite and microwave heating in the recovery of Mn(IV) is expected to effectively reduce the use of sulfuric acid, and achieve green, environmentally friendly and efficient leaching of manganese.

Natural Pyrite-assisted Mechanochemical Recovery of Insoluble Manganese from Electrolytic Manganese Residue: Kinetics and Mechanisms

Enhanced manganese leaching from electrolytic manganese residue by electrochemical process and Na2SO3

Manganese Removal from Aqueous Solution Using a Thermally Decomposed Leaf

Environmentally-friendly biorecovery of manganese from electrolytic manganese residue using a novel Penicillium oxalicum strain Z6-5-1: Kinetics and mechanism

Insight into mechanisms of Mn and NH 4 + -N removal with recovery of Mn and Mg from electrolysis manganese residue (EMR): Effect of humus and NaOH

Enhanced Leaching of Mn from Electrolytic Manganese Anode Slime via an Electric Field

Immunostaining for ubiquitin: efficient pretreatment

Study on harmless treatment of electrolytic manganese residue by low temperature thermochemical method

Efficiency and sustainable leaching process of manganese from pyrolusite-pyrite mixture in sulfuric acid systems enhanced by microwave heating

Solidification/stabilization and separation/extraction treatments of environmental hazardous components in electrolytic manganese residue: A review

Microwave-enhanced reduction of manganese from a low-grade pyrolusite ore using pyrite: process optimization and kinetic studies

Enhanced removal of Mn2+ and NH4+-N in electrolytic manganese residue leachate by electrochemical and modified phosphate ore flotation tailings

Microwave efficient extraction of manganese from low-grade pyrolusite by pyrite reduction acid leaching process

An innovative method for manganese (Mn2+) and ammonia nitrogen (NH4+-N) stabilization/solidification in electrolytic manganese residue by basic burning raw material

An Environmentally Friendly Approach for the Extraction and Recovery of Mn from Pyrolusite by Ammonium Sulfate Roasting‐water Leaching and Ammonium Carbonate Precipitation

A Green Method for Mn2+ and NH4+-N Removal in Electrolytic Manganese Residue Leachate by Electric Field and Phosphorus Ore Flotation Tailings

Clean Stepwise Extraction of Valuable Components from Electrolytic Manganese Residue via Reducing Leaching–Roasting

Hazard-Free Treatment of Electrolytic Manganese Residue and Recovery of High-Concentration SO2 Using High-Temperature Reduction Roasting Process

Changes in Microbial and Metabolic Pathways of Solidifying Manganese and Removing Nitrogen from Electrolytic Manganese Residue by the Sulfate-Reducing Bacteria

Enhanced removal of Mn2+ and NH4+-N in electrolytic manganese metal residue using washing and electrolytic oxidation

Innovative Techniques for Electrolytic Manganese Residue Utilization: A Review