Abstract:With the proliferation of RFID-enabled applications, multiple RFID readers (or reader antennas) must be used to provide full coverage to any deployment area beyond the communication range of a single reader. However, reader collision together with tag-to-tag collision seriously degrades the system performance or even blocks out some tags from being read. To address this problem, this paper proposes a time-efficient protocol stack that is tailored to the tag identification in a multi-reader RFID system, which consists of two protocols: one is for eliminating reader collision (RCE) and the other is for avoiding tag-to-tag collision (TCE). In RCE, we enable multiple readers to work in parallel for maximizing the number of tags to be read per unit of time. Where RCE shines is that it well addresses the problem of unbalanced load by each reader due to uneven tag distributions. Namely, in existing work, the readers with fewer tags covered will finish the tag identification earlier than other readers (with more tags). After that, these readers have to wait for all readers until they are done. This is a waste of time. The solution of RCE is to take the reader with the minimum number of tags as the reference and iteratively to update the set of concurrent readers. Besides, in TCE, we use bit-level tag response to resolve tag-to-tag collision and increase the number of useful slots, so does the read throughput. Theoretical analysis and simulation results show that the above two protocols can jointly improve the inventory efficiency and reduce the identification time by more than 50%, in comparison to the state-of-the-art. We validate TIMR’s performance by comparing its results on a real-world library data set with simulated data, demonstrating consistency across both settings.

DenseNet-based RFID Grouping Protocols

Fast RFID Grouping Protocols

Efficient RFID Grouping Protocols.

A Near-Optimal Protocol for the Grouping Problem in RFID Systems

Efficient Tag Grouping Via Collision Reconciliation and Data Compression

Dynamic Grouping in Rfid Systems

STEP: A Time-Efficient Tag Searching Protocol in Large RFID Systems

Dual-Reader Wireless Protocols for Dense Active Rfid Identification

A Protocol for Simultaneously Estimating Moments and Popular Groups in a Multigroup RFID System

Fast and Reliable Missing Tag Detection for Multiple-Group RFID Systems

Complete and Fast Unknown Tag Identification in Large RFID Systems

Less is More: Efficient RFID-Based 3D Localization

Efficient Misplaced-Tag Pinpointing in Large RFID Systems.

A Multi-Reader Joint Detection Scheme for Dense RFID Networks

An IDMA-based detection scheme for dense RFID networks

Non-blocking tag scanning for passive RFID localization.

Fast Cloned-Tag Identification Protocols for Large-Scale RFID Systems

A Protocol Stack for Large-Scale RFID Systems: Mitigating Reader and Tag Collisions

High Performance Tag Singulation for Memory-Less Rfid Systems

A Range-Free Localization of Passive Rfid Tags Using Mobile Readers

Multi-Seed Group Labeling in RFID Systems