Abstract:Open-loop controlled hydraulic manipulators are still dominating in construction sites and forest fields thanks to little reliance on the expertise of human operators in manipulator control, which however exist large inlet/outlet and other energy losses during working cycles. And the situation further deteriorates with the increasing number of joints. This paper discusses the problem of global energy optimization of three-degrees-of-freedom (3-DOF) hydraulic manipulator in case of plane motion where exists an exceeding DOF for motion redundancy. Different from conventional energy optimization methods applied to electric driven manipulators, the proposed global energy-optimized dynamic programming (DP) algorithm models the whole system at the hydraulic level, which contains the dynamic characteristics of pressure-flow coupling between cylinders. The energy consumption models of constant pressure (CP), load-sensing (LS) and electrohydraulic load-sensing (ELS) systems are built in terms of cost functions formulated in the proposed algorithm together with penalty function containing physical actuator constraints at position, velocity and acceleration level. The DP algorithm is tested in various cases, and the convergence is proved consistent. To highlight the effectiveness of the proposed algorithm, the gradient projection (GP) method and the actuator velocity minimum norm (MA) method are introduced as a contrast. The results of the numerical examples of end-effector paths using the mechanical-hydraulic coupling AMESim model demonstrate that the DP algorithm saves around 10.49% hydraulic energy consumption in the CP system while saving around 76.55% in the LS system. Experiments performed on a typical-structured hydraulic manipulator further validate the effectiveness of the proposed algorithm, with approximately 4.61% energy saving in the CP system and 29.89% in the LS system. The energy-saving ratio is even larger in the ELS system, with around 80.03% comparing the max value. These contribute to the energy optimization resolution of redundant hydraulic manipulators to a degree.

Structural Design of Maintenance Manipulator for Steam Generator in Nuclear Power Plant

Dynamic Modeling and Analysis for Coupling Processing 6-DOF 3 P3 R Manipulator

Dynamic Modeling and Trajectory Tracking Control of a Novel Muck-Removal Hydraulic Manipulator

Hydraulic Systems Control Based on the Characteristics of Major-Motion Mechanism for an Open-Die Forging Manipulator

The structural design and simulation of the tubing handling manipulator

Hydraulic System Design and Simulation of the Forging Manipulator

Design of gearing chain-based manipulator for post-processing

Development of a redundant anthropomorphic hydraulically actuated manipulator with a roll-pitch-yaw spherical wrist

The structure design and kinematics analysis of the manipulator for the upper port remote maintenance in DEMO

Global Energy Efficiency Improvement of Redundant Hydraulic Manipulator with Dynamic Programming

Structural Design and Analysis of the Truss Manipulator

A Study on the Stiffness of the End of the Suspended Master–slave Remote Control Manipulator

Workspace Description and Evaluation of Master-Slave Dual Hydraulic Manipulators

Study on a master-slave underwater manipulatorfor nuclear power plant servicing

Design and Analysis of 7-DOF Cable-Driven Manipulator

Kinematic Modelling Analysis and Simulation of 6-DOF Manipulator

Kinematics analysis of a novel hybrid manipulator for optomechanical modules assembly

Kinematics Modeling And Workspace Analysis Of A 5-Dof Hydraulic Manipulator

Dynamic analysis of multi-functional maintenance platform based on Newton-Euler method and improved virtual work principle

Design and Control of an Ultra-Slender Push-Pull Multisection Continuum Manipulator for In-Situ Inspection of Aeroengine

Screw-based dynamics of a serial/parallel flexible manipulator for DEMO blanket remote handling