Abstract:For low costs, numerical simulation is an effective method to reveal the internal mechanisms inside a thermal plasma torch. Various simulation models for studying the inside or outside characteristics of thermal plasma torches have been built and discussed. However, to reveal the inside mechanisms of thermal plasma torches under various working conditions to support the materials processing, more attention should be paid to building precise models of laminar plasma torches. Thus, based on the user-defined function (UDF) and user-defined scalar (UDS) of ANSYS Fluent software, the assumptions, governing equations, boundary conditions, and solving method were discussed in detail, and a corresponding numerical model of a homemade laminar plasma torch was first built. For verifying the effectiveness of the proposed numerical model and studying the influence of the gas components on the arc characteristics, the working conditions and experimental setups were introduced in sequence. Finally, the numerical and experimental results of the homemade laminar plasma torch were obtained and discussed in detail. The study results show that: 1 The axial temperature of the plasma torch could be divided into three sections along the axis: peak temperature area (10 mm < x < 20 mm), stable temperature area (20 mm < x < 62 mm) and decrease temperature area (62 mm < x < 95 mm). Under the same input conditions, when pure argon gas was used, the peak temperature at the outlet was reached at approximately 7590 K, while for pure nitrogen and 50%Ar + 50%N2, the corresponding peak temperatures were 6785 K and 7402.2 K, respectively. 2 The axial velocity of pure nitrogen is much higher than that of pure argon and 50%Ar + 50%N2, while that of pure argon and 50%Ar + 50%N2 has little difference. In addition, when nitrogen gas was used, the peak velocity at the outlet reached 185 m/s, whereas, for argon gas and 50%Ar + 50%N2, the corresponding peak velocities were 146 m/s and 169 m/s, respectively. 3 The simulated arc voltage trends under different working conditions are well in accordance with the experimental arc voltage trends.

Arc Column Oscillation: A New Mode of Arc Fluctuation in Laminar Plasma Torch

Fluctuation of arc plasma in an arc plasma torch with multiple cathodes

Fluctuations of DC atmospheric double arc argon plasma jet

Arc Fluctuations in a Double Anode Plasma Torch at Atmospheric Pressure

Alternating current-driven non-thermal arc plasma torch working with air medium at atmospheric pressure

A Distributed Carbon Cathodic Vacuum Arc

Dynamic behaviour of dc double anode plasma torch at atmospheric pressure

Physical Characteristics of Gliding Arc Discharge Plasma Generated in a Laval Nozzle

Experimental Study of the Discharge Characteristics of a Magnetically Stabilized Double-Chamber Arc Plasma Torch

Extension Of Flammability And Stability Limits Of Swirling Premixed Flames By Ac Powered Gliding Arc Discharges

Re-igniting the Afterglow Plasma Column of an AC Powered Gliding Arc Discharge in Atmospheric-Pressure Air

Electrical and Spectroscopic Diagnostic of an Atmospheric Double Arc Argon Plasma Jet

Experimental Study on the Characteristics of a Miniature Laminar Plasma Torch with Different Gas Flow Patterns

Modeling of the Arc Characteristics inside a Thermal Laminar Plasma Torch with Different Gas Components

Characterization Of An Atmospheric Double Arc Argon-Nitrogen Plasma Source

The Nature of Fluctuations in A Double Arc Argon-Nitrogen Plasma Jet

Modelling Study on the Plasma Flow and Heat Transfer in a Laminar Arc Plasma Torch Operating at Atmospheric and Reduced Pressure

Dynamic behaviour of alternating current arc discharge in a multi-arc generator at atmospheric pressure

Experimental Study on the Jet Characteristics of a Steam Plasma Torch

Experimental Study on Arc Images and Voltage Fluctuation of Magnetically Driven Arcs

Experimental Study on the Restrike Mode of a DC Arc Anode Attachment