Abstract:White organic light-emitting devices based on a red fluorescent dye 3-（dicyanomethylene）-5, 5-dimethyl-1-（4-dimethylamino-styryl） cyclohexene（DCDDC） were fabricated and investigated. Two kinds of devices were processed using ultrathin technology and doping technology. The structures of the devices were as followed: 1） indium-tin oxide （ITO）/N, N′-diphenyl-N, N′-bis（1-naphthyl-pheny1）-1, 1′-biphenyl-4, 4′-diamine （NPB）/4, 4′-bis（2, 2′-diphenylvinyl）-1, 1′-diphenyl （DPVBi）/tris（8-quinolinolato） aluminum （Alq3）/DCDDC/Alq3/Mg:Ag; 2） ITO/NPB /Alq3:DCDDC/NPB/2, 9-dimethyl-4, 7-diphenyl-1, 10-phenanthroline （BCP）/Mg:Ag. The luminescence and efficiency characteristics of these two devices were measured and compared. The results showed that both devices A and B exhibited white light consisting of RGB three primary colors. Moreover, device A had a turn on voltage of 4 V, a maximum power efficiency of 2.4 lm/W at 5.5 V and a maximum luminance of 16690 cd/m2 at 185 V. Also, pure white emission with Commissions Internationale De L’Eclairage （CIE） coordinates near （0.330. 0.300） having a slight variation of （-0.020, +0.002） in a wide range of voltages was observed. In contrast, devices B showed a turn on voltage of 5 V, a maximum power efficiency of 1.4 lm/W at 5.5 V and a maximum luminance of 12580 cd/m2 at 17 V. The CIE coordinates had a red shift as the voltage increased and then kept near the optimum white point of （0.33, 0.33） over 9 V. It was found that the difference in characteristics of these two devices was dependent on the variation of charge recombination zone. To be specific, it was due to the direct charge trapping effect of DCDDC ultrathin layer and the properties of incomplete energy transfer in Alq3:DCDDC doping system.

Ge-alloyed Quasi-two-dimensional Perovskite Light-emitting Diodes

Quasi-2D Perovskite Light-emitting Diodes with Fluorophenethylammonium as Organic Cations

Synthesis and Electroluminescence Properties of Deep Blue Materials Based on Anthracene Core

Quantum-dot Light-emitting Diodes Based on MoO<sub>3</sub>/ZnO Inorganic Charge-generation Layer

Germanium-lead Perovskite Light-Emitting Diodes.

Energy-Efficient Perovskite LEDs with Rec. 2020 Compliance

Progress of Ultraviolet/Deep-blue OLED Luminescent Materials

Flexible Reflectance-type Electrochromic Devices Based on Cr/Ag/WO3 Thin Films

PbS Quantum Dot Doped Polymer Broadband Optical Fiber Amplifier

Luminescence Properties of Narrow‐band Red Phosphor CaTiF<sub>6</sub>·2H<sub>2</sub>O∶Mn<sup>4+</sup> for Warm White Light-emitting Diodes with High Color Rendering Index

Research Progress of Electroluminescent Materials and Devices Based on Exciplex Excited State

High-performance large-area quasi-2D perovskite light-emitting diodes

Optoelectronic Properties and Photodetection of Two-dimensional Black Phosphorus

Perovskite Light‐Emitting Diodes with EQE Exceeding 28% through a Synergetic Dual‐Additive Strategy for Defect Passivation and Nanostructure Regulation

Research Progresses on Polycrystalline Thin-film Organic Light-emitting Diodes Based on Weak-epitaxy-growth Technique

Perovskite Light‐Emitting Diodes with an External Quantum Efficiency Exceeding 30%

Efficient Perovskite Nanograin Light‐Emitting Diodes in Green‐to‐Blue Gamut with co‐Additive Engineering

Ions-induced Assembly of Perovskite Nanocomposites for Highly Efficient Light-Emitting Diodes with EQE Exceeding 30

High-Performance All-Inorganic Architecture Perovskite Light-Emitting Diodes Based on Tens-of-Nanometers-Sized CsPbBr3 Emitters in a Carrier-Confined Heterostructure

Perovskite Light‐Emitting Diodes with External Quantum Efficiency Exceeding 22% via Small‐Molecule Passivation

High Performance White Organic Light-Emitting Devices Based on A Novel Red Fluorescent Dye 3-(Dicyanomethylene)-5, 5-Dimethyl-1-(4-dimethylamino-styryl) Cyclohexene