Abstract:This article presents an 18 similar to 30 GHz vector-sum phase shifter for wireless application in the millimeter-wave regime. It is composed of an I/Q signal generator, two variable-gain amplifiers (VGA), and a digital-to-analog converter with a quadrant selector. To attain wideband quadrature signal, a two-stage hybrid based on transformers is proposed to realize the I/Q signal generator. The first- and second-stage hybrids are designed with different resonating frequencies. As a result, the amplitude and phase errors of the I/Q signal generator are significantly decreased in a wide frequency band. In addition, theoretical analysis based on a simplified equivalent-circuit model is performed to guide the circuit implementation, and its correctness is demonstrated by electromagnetic simulation. To mitigate the impact of the VGAs' parasitics on the phase performance, a capacitive-neutralization technique is applied to cancel parasitics of transistors in the VGAs. A prototype circuit is designed using a 130-nm SiGe BiCMOS process. The measured results show that the circuit achieves a root-mean-square (RMS) amplitude error of less than 1.4 dB and an RMS phase error of 1.4 degrees similar to 3.4 degrees across 18 similar to 32 GHz. The tested peak gains of all the phase states are -1 similar to 4.5 dB with an input balun (approximate to 1.9 dB loss) and an output balun (approximate to 2 dB loss) at 22 GHz. Also, the input 1-dB compression point and noise figure are tested, which are >=-1 dBm and <= 15.5 dB in the targeting frequency band.

6-Bit CMOS Phase Shifter and Attenuator Based on Time-Modulation for Ku-band Phased Array Applications

An E-band Subradix Active Phase Shifter with < 0.69° RMS Phase Error and 16-Db Attenuation in 28-Nm CMOS

A 6-Bit CMOS Active Phase Shifter for Ku-Band Phased Arrays

An Ultra Broadband Passive Vector Modulator Phase Shifter

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

A Wideband 6-Bit Phase Shifter with Low RMS Error in 65nm CMOS Technology

Design of a Low-Insertion-phase-shift MMIC Attenuator Integrated with a Serial-to-parallel Converter

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

An 800-Ps Origami True-Time-Delay-Based CMOS Receiver Front End for 6.5–9-Ghz Phased Arrays

A Ku-Band 6-Bit Vector-Sum Phase Shifter with Half-Quadrant Control Technique

A Ku-band 180° Phase Shifter with 2-Bit Attenuation Control Based on High-pass/low-pass Network

A 26-32Ghz 6-Bit Bidirectional Passive Phase Shifter with 14dbm IP1dB and 2.6° RMS Phase Error for Phased Array System in 40nm CMOS

A 14-18Ghz 6bit Passive Phase Shifter in 0.13µm SiGe BiCMOS

A 4-Bit CMOS Phase Shifter for Millimeter-Wave Phased Arrays

A 6-Bit Phase Shifter with Low RMS Phase Error and Flat Gain Across 1.9–2.6Ghz

A C-band CMOS Transmitter with a 6-bit Phase Shifter and Power Amplifier for Phased Array Systems

A 32-40 GHz 7-bit Bi-Directional Phase Shifter With 0.36 dB/1.6 RMS Magnitude/Phase Errors for Phased Array Systems

A CMOS K-Band 6-Bit Attenuator with Low Phase Imbalance for Phased Array Applications

Design and Analysis of a 26–32-Ghz 6-Bit Passive Vector Modulation Phase Shifter for CMOS Bidirectional Transceiver

A 27–31 ghz 6-Bit Phase Shifter with Low Phase Error/gain Variation in 65 nm CMOS

A 25-35 GHz 5-Bit Digital Attenuator with Low RMS Amplitude Error and Low Phase Variation in 65 Nm CMOS.