Abstract:Autothermal reforming of methane (ATR) technique is a promising technology for H2 production. Soot formed in the combustion region of ATR may deactivate the downstream catalyst used to enhance the reforming reactions. In this work, the effects of CO2/CH4 ratio on soot production and main gas-phase components involved in reforming reactions were investigated by experiment and numerical simulations in laminar inverse coflow diffusion flames, at conditions close to ATR. The CO2/CH4 ratio ranges from 0.27 to 4.90, and the pressure ranges from 1 atm to 10 atm. The oxidant consists 70% O2 and 30% N2 to mimic the oxy-combustion in the ATR process. The soot, polycyclic aromatic hydrocarbon (PAHs), OH* distribution, and flame structure were measured using planar laser-induced incandesce, planar laser-induced fluorescence, OH* luminescence, and flame luminescence, respectively. High fidelity simulations with a reduced gas-phase kinetic mechanism and soot aerosol models were also undertaken to supplement the findings. The results show that soot formation is suppressed by a higher CO2/CH4 ratio, while the level of soot reduction is attenuated as the pressure increases. The peak soot volume fraction increases with the flame height, and then levels off. PAHs concentration monotonically increases with flame height. The spatial distributions of PAH and soot along flame height were not well captured by numerical simulations, and the used physical based soot inception model is expected to account for the discrepancy. The peak soot volume fraction correlates with CO2/CH4 ratio by an exponentially decaying function, with the exponent decreasing with increasing pressure. A similar trend of PAHs concentration along with CO2/CH4 ratio was also observed. Non-sooting flame is achievable at elevated pressure if the CO2/CH4 ratio is higher than 4.0, at the expense of lowering the syngas yield in the combustion region. The simulations also predicted that the flame temperature and concentration of H2 and CO decrease with CO2/CH4 ratio.

Influence of Pulse Repetition Frequency on CH 4 Dry Reforming by Nanosecond Pulsed Dielectric Barrier Discharges

The Coupling Performance During Reactive Sorption Enhanced Reforming (reser) Process: Simulation and Experimental Studies

Chemical Insights into Plasma-Assisted Dry Reforming of Methane in a Nanosecond Discharge

CH4 reforming with CO2 using a nanosecond pulsed dielectric barrier discharge plasma

Chemical Effect of CH4 on NH3 Combustion in an O2/N2 Environment Via ReaxFF

Characterization of CH4-CO2-O2 Diffusion Flames Near Autothermal Reforming Condition

The Effects of CO2/CH4 Ratio on Soot Formation for Autothermal Reforming of Methane at Elevated Pressure

Reaction mechanism explorations on non-thermal plasma reforming of CO2-CH4 by combining kinetics modeling and emission spectroscopy measurements

CH$_4$ reforming with CO$_2$ in a nanosecond pulsed discharge. The importance of the pulse sequence

Investigation of Dry Reforming of Methane in a Dielectric Barrier Discharge Reactor

Effect of Nanosecond Pulse Discharge on Emission Spectral Behavior in CH4-Air Diffusion Flame

Experimental Investigation on DBD Plasma Reforming Hydrocarbon Blends

Facilitating CO2–CH4 Reforming Into Syngas and Useful Chemicals by Water‐Cooled Dielectric Barrier Discharge Plasma: Effect of Discharge Power, Gas Mixing, and Mechanism Insight

Dry Reforming of Methane with Carbon Dioxide Using Pulsed Dc Arc Plasma at Atmospheric Pressure

Pulsed laser induced plasma and thermal effects on molybdenum carbide for dry reforming of methane

Plasma-Assisted Dry Reforming of CH 4 : How Small Amounts of O 2 Addition Can Drastically Enhance the Oxygenate Production─Experiments and Insights from Plasma Chemical Kinetics Modeling

Influence of balance gas mixture on decomposition of dimethyl sulfide in a wire-cylinder pulse corona reactor.

Optimization of Discharge Plasma Reactor for Dry Reforming of Methane using Response Surface Methodology

Steam Enhanced Carbon Dioxide Reforming of Methane in DBD Plasma Reactor

Analysis of dry reforming of methane under different fluidization regimes using a multiphase particle-in-cell approach

Can post-plasma CH 4 injection improve plasma-based dry reforming of methane? A modeling study