Abstract:Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, Ahead of Print. Due to the high speed and high pressure operating conditions, wear between the finger seal and the rotor is inevitable, and this leads to an increase of leakage clearance and becomes an important factor affecting the seal life. The theory of anisotropic elasticity was employed to describe the mechanical characteristics of the seal material. An improved Archard wear model was proposed to calculate the nodal wear rate, and the local wear direction was also determined. The wear simulation model and procedure were established based on the Arbitrary Lagrangian Eulerian adaptive mesh strategy. The effects of material density, fabric orientation, pressure differential and rotor speed on the wear characteristics of finger seal and the change of leakage clearance caused by wear loss were studied. The results show that the wear first occurs at the heel area of the finger foot bottom and gradually extends to the toe area. C/C (carbon fibre reinforced carbon matrix) composite finger seal with higher material density has smaller leakage clearance and wear depth. With the increase of fabric orientation angle, the wear depth in the heel area of finger foot is smaller, and the circumferential wear area is narrower. The average wear depth of finger seal decreases with the orientation angle. When the orientation angle is 0, the seal leakage clearance is smaller. The increase of pressure differential not only aggravates the seal wear, but also expands the wear area, and also increases the average contact pressure and leakage clearance. Increasing the rotor speed make the wear depth of the heel area of finger foot gradually increase, but the wear area becomes narrower. The average contact pressure decreases and the average leakage clearance increases. This study provides a theoretical method and basis for the prediction and evaluation of the wear life and performance of C/C composite finger seal.

Numerical investigations into the rubbing wear behavior of honeycomb seal

The Wear of Seal Fins During High-Speed Rub Between Labyrinth Seal Fins and Honeycomb Stators at Different Incursion Rates.

Investigations into rubbing wear behavior of honeycomb land against labyrinth fin with periodic-cell model

Investigation of High-Speed Rubbing Behavior of Labyrinth-Honeycomb Seal for Turbine Engine Application

The Influence of the Axial Rub Added in the Radial Rub on the Wear of the Seal Fins during the High Speed Rub of Labyrinth-Honeycomb Seal

Investigation of High-Speed Abrasion Behavior of an Abradable Seal Rubber in Aero-Engine Fan Application

Experimental Study on Rubbing Wear Characteristics of Labyrinth Seal with Trapezoidal Fins

Experimental Investigation on Wear Behavior of Rectangular Labyrinth Fin Against High-Speed Rotor

Numerical and Experimental Study On the Influence of Honeycomb Bushing Wear On the Leakage Flow Characteristics of Labyrinth Seal

Investigations on conjugate heat transfer performance of honeycomb seal

Numerical Investigations of Leakage Performance Degradations in Labyrinth and Flexible Seals Due to Wear

Investigations on the Discharge and Total Temperature Increase Characteristics of the Labyrinth Seals with Honeycomb and Smooth Lands

An Experimental Study on Friction Contact Between Chamfered Labyrinth Fin and High Speed Rotor

Investigations of the Conjugate Heat Transfer and Windage Effect in Stepped Labyrinth Seals

Investigation on the Discharge and Windage Heating Characteristics of Staggered Labyrinth Seals under Adiabatic and Heat Transfer Models

Wear modelling and sealing performance prediction of C/C composite finger seal

Numerical Investigations on Leakage Performance of the Rotating Labyrinth Honeycomb Seal

Effects of Mushroom-Shaped Tooth Wear on the Leakage Performance and Rotordynamic Coefficients of Labyrinth Seals

Effect of Teeth Bending and Mushrooming Damages on Leakage Performance of a Labyrinth Seal

Prediction of Seal Wear with Thermal-Structural Coupled Finite Element Method

Study on Flow and Total Temperature Increase of Honeycomb Labyrinth Seals