Abstract:To enhance the dynamic performance and disturbance rejection capability of the permanent magnet synchronous motor speed control system, a novel speed control method based on a novel sliding mode control (NSMC) and load torque observer is proposed on the basis of model predictive current control (MPCC) with a sliding mode disturbance observer. First, on the basis of MPCC, the influence of parameters such as resistance, inductance, and flux linkage on MPCC is analyzed. To address the aggregated disturbance caused by parameter mismatches, a piecewise square-root switching function sliding mode disturbance observer (SMDO) is designed to enhance the robustness of the parameters. To address the poor dynamic performance and inadequate robustness resulting from the proportional-integral-controller (PI) velocity loop control in the MPCC, a novel NSMC velocity control method is proposed. This method utilizes the hyperbolic sine function and fractional-order integral sliding mode surface, resolving the dilemma faced by traditional slide mode controllers (SMC) in balancing fast response and reduced vibration. Additionally, to enhance the system’s disturbance rejection capability, a sliding mode torque observer (SMTO) is designed to continuously update the observed load torque value into the NSMC controller, achieving speed compensation control. Finally, through comparative experiments among the proportional integral controller (PI), SMC, NSMC, and NSMC + SMTO, the results indicate that the proposed NSMC + SMTO exhibits the best speed response, steady-state characteristics, and disturbance rejection capability.

Adaptive Complementary Sliding Mode Control for Synchronous Reluctance Motor With Direct-Axis Current Control

Hybrid Frame-Based Current Control Scheme for LC-Equipped PMSM with Non-Sinusoidal Back-EMF

A Modulated Model-Free Predictive Current Control for Four-Switch Three-Phase Inverter-Fed SynRM Drive Systems

Independent Current Control of Dual Parallel SRM Drive Using a Public Current Sensor

An I/f Control Method With Closed-loop Regulation of Current Vector for Surface Permanent Magnet Synchronous Motor Drives

Nonlinear Speed Sensorless Control Of Pmsm Drives

Disturbance-Observer-Based Sliding-Mode Speed Control for Synchronous Reluctance Motor Drives via Generalized Super-Twisting Algorithm

Speed Synchronization Control of Dual-SRM Drive with ISMC-based Cross-coupling Control Strategy

Adaptive Pseudorandom High-Frequency Square-Wave Voltage Injection Based Sensorless Control for SynRM Drives

Model-Free Predictive Current Control for SynRM Drives Based on Optimized Modulation of Triple-Voltage-Vector

An enhanced direct torque control strategy with composite controller for permanent magnet synchronous motor

On a SMR-Fed SynRM Drive With Real-Time Commutation Tuning

Research on Compound Sliding Mode Control of a Permanent Magnet Synchronous Motor in Electromechanical Actuators

Direct torque control for synchronous reluctance motor based on space vector modulation

Super-Twisting Algorithm Second-Order Sliding Mode Control for a Synchronous Reluctance Motor Speed Drive

Sliding Mode Speed Control for PMSM Based on Model Predictive Current

Speed-current composite loop SPMSM control based on ADR-SMC

Dual Cost Function Model Predictive Direct Speed Control with Duty Ratio Optimization for PMSM Drives

A Combined Control Strategy over Full Speed Range of Synchronous Reluctance Motor Considering Iron Loss

Maximum Torque Per Ampere Sensorless Control of SynRM Based on Mixed Signal Injection and Extended Back-EMF