Abstract:Introduction: Molar tip back bends added on steel wire is a classical anchorage control method used in Tweed Edgewise and Begg technique. With the development of straight wire appliance (SWA), especially the wide use of Nickel-titanium (NiTi) wire makes bending up impractical in the first stage of the treatment. However, mesial movement of molars occurs when fine NiTi wire was engaged into the molar buccal tube with forward tipping prescription. This single-center 2-arm parallel randomized clinical trial aimed to compare the physiologic anchorage spee-wire system (PASS) vs MBT™ straight-wire system with regards to their capacity of anchorage control during alignment and leveling. Method: The sample consisted of 64 CL I/ CL II orthodontic patients who underwent maxillary first premolar extraction. Minimal randomization was used to select the sample. Two bracket systems were used—PASS and MBT™. The digital study models included three time points: pre-treatment(T0), the first 3 months during treatment(T1), and the first 6 months during treatment(T2). Study models of different time point were superimposed and movements of maxillary first molar, canine, and central incisor were evaluated. Results: In the first 6 months of the treatment, the maxillary first molars were tipped distally (2.67±4.59°) and moved distally(0.03±1.02mm) in the PASS group; They were tipped mesially(1.95±3.04°) and moved mesially (0.67±0.79mm) in the MBT™ group. Vertically, the maxillary first molars were slightly extruded in the PASS group – the mesial cusp 0.50±0.73mm and the distal cusp 0.18±0.67mm; however, they were intruded in the MBT™ group – the mesial cusp 0.19±0.52mm and the distal cusp 0.05±0.56mm. Besides molars, the maxillary canines also exhibited treatment difference– the inter-canine width was increased by 1.31±2.00mm in the PASS group in contrast to 2.37±1.72mm in the MBT™ group. No other difference was found. Conclusion: Compared with MBT™, PASS was better at preserving maxillary anchorage during alignment and leveling.

Tip—EdgePlus和MBT技术治疗安氏II错[牙合]畸形引起牙根吸收的比较研究

Dento-alveolar changes ofbimaxillary protrusion patients treated with MBT pre-adjusted technique

Vertical changes inskeletal Class I patients after premolarextractions

Comparison Between Tip-Edge Plus and Straight Wire Techniques in the Treatment of Class Ⅱ Division 1 Patients

Use of PAR index in assessing occlusion relationship with different Angle classification

安氏II^2错（牙合）伴有上颌尖牙腭侧阻生患者的矫治

Effect of root formation on the cleft canine eruption after secondary alveolar bone grafting

Dentofacial Changes at the Three Different Stages on the Malocclusion with Severe Overbite and Overjet Treated by Tip-Edge Plus Technique

[Comparison of the application of micro-implant screw support and flat guide plate in the treatment of excessive deep overbite of lower anterior teeth]

[The Differences of Hard Tissue Changes and Stability of Angle's Class II Division 1 Extraction Cases Treated by Begg Appliance and Edgewise Appliance].

Preliminary investigation on orthodontic treatment with first molar extraction

[Preliminary Investigation of Tip-Edge Plus Technique in the Treatment of Class III Malocclusion].

The Keys to Success of Extraction Treatment in Lingual Orthodontics

The Preliminary Clinical Study of Posterior Vertical Control of High Angle Non-Openbite Extraction Cases Through Microscrew Implant Anchorage

[Compensation of Upper First Molar in Skeletal Class Ⅲ Patients Treated with Orthodontic-Surgical Treatment].

A investigation of dental arch width in the patients of bilateral cleft lip and palate after operation

Comparison of the Measurement Result of Available Alveolar Bone Based on Two Different Graphical Methods

Analysis of the assessment methods of secondary alveolar bone grafting in patients with cleft lip and palate

Effects of Torque Control by Tip-Edge Plus and Damon Self-ligating Brackets in Extraction Cases

Three-dimensional Change of Molar Position During Alignment and Leveling with PASS and MBT™: a Randomized Controlled Trial

Transverse Compensation Of First Molars In Different Sagittal And Vertical Classifications: A Retrospective Study Using Cone-Beam Computed Tomography