Abstract:The retention of austenite after heat treatment may improve the ductility and toughness of steel parts.In 20th century,we applied the thermal stabilization of austenite in order to reduce the deformation during quenching for steel parts(during tempering for high speed steel).This article introduces the new process(quenching and partitioning process) for steel heat treatment developed by J.Speer et al,i.e,quenching at a temperature between Ms-,followed by partitioning treatment either at initial quenching temperature or above Ms,designed to enrich the remain-ing untransformed austenite with carbon,escaping from the martensite,thereby stabilizing retained austenite for Q-P steel containing Si and(or) Al,increasing the amount of retaining austenite after last quenching at room temperature and improving the combination of strength and toughness of steel parts.Some examples are taken to illustrate that steels show good mechanical properties after treated with Q-P process.Experiments have shown that the assumed constrained conditions for thermodynamical model of constrained carbon equilibrium(CPE,CEE)often not exist during the partitioning.It is suggested that orthoequilibrium should be a theoretical base for partitioning,especially at higher partitioning temperature for longer time.The △G values for different probable transformations should be calculated in order to predict the transformations which may occur,including the precipitation of carbides,γ→α and M(α) →γ,during the partitioning.Extent of carbon partition between martensite and austenite may proceed according to diffusion kinetics.Based on the Q&P process,new heat treatment processes,such as quenching-partitioning-tempering(Q-P-T),local carburization of steel parts as well as partitioning treatment for high strength steel are suggested

General Rule and Promising Future of Mechanical Energy Aided Thermal Diffusing Process

Development and Advances in Cryogenic Treatment Technique and Device

Study for Diffusion Process in Chemical Heat Treatment

The Generalized Additivity Rule for Thermal Path-Dependent Diffusion-Controlled Phase Transformation by Simultaneous Nucleation and Growth and Its Mathematical Solutions

Mechanisms and Methods for Diffusion Process in Solid Metals

Application of the Thermodynamic Extremal Principle to Diffusion-Controlled Phase Transformations in Fe-C-X Alloys: Modeling and Applications

Interface Behaviors and Mechanical Properties of Diffusion Bonded 45 Steel/additive Manufactured 316L Steel Joints

Action of Rolling on Mechanical Energy Aided Aluminizing Processes

Computational Thermodynamics/kinetics Aided Design for the Microstructure of Pearlitic Steels During Cooling Process

New Processes for Steel Heat Treatment*

Diffusion and Micro-Alloying Mechanism of Rare Earth(re) and Carbon/nitrogen Atoms Permeated into Surface Layer of Steel During RE-carburizing,-nitriding And-Nitrocarburizing

Effect of Electric and Magnetic Field on Element Diffusion and Annealing Process in Metallic Material

Mechanical behaviors of metallic alloys dominated by thermo-kinetic synergistic effects upon materials processing

Design and Experimental Verification of Thermal Protective Materials Based on the New Thermal Protective Mechanism

Application of the Thermodynamic Extremal Principle to Diffusion-Controlled Phase-Transformations in Multi-Component Substitutional Alloys: Modeling and Applications

Diffusion bonding of high entropy alloy and stainless steel at a relative lower temperature via surface nano-crystallization treatment

Significant efficiency improvement of conventional tempering by a novel flash tempering technique

Application of Electric Field During the Heat Treatment: the Device Development and the Effect on Mechanical Properties of AA 6082

Investigation of the thermal behavior during the direct writing metal additive manufacturing

Micromachined structures decoupling Joule heating and electron wind force

Surface Engineering for Phase Change Heat Transfer: A Review