Abstract:Upward- (UFS) and downward (DFS) flame spread along a vertical installed electrical wire has been examined experimentally to gain better understandings of the heat transfer mechanism and burning behavior over electrical wires. UFS is considered as a much more hazardous fire scenario than DFS, however, UFS over electrical wires was very limited addressed. Fundamentally, the controlling heat transfer boundary over the preheating zone, hence the flame spread behaviors are quite different between DFS and UFS. This problem is more complicated for an electrical wire, for which the metal conduction is involved additionally, playing an important role in the heat transfer process. Thirteen types of polyethylene-insulated electrical wires with Cu- and NiCr-core were used to investigate the effect of metal core thermal conduction and wire configuration for both UFS and DFS. During the flame spread process, the pyrolysis length of UFS was enlarged, while only portion of virgin material of DFS were burnt as the result of distinct dripping. By further concerning the curvature effect, the dependence of the flame length on heat release rate per unit width (i.e. perimeter for cylinder) can be well explained by non-dimensional analysis. It turns out that the growth of flame length will be restrained as radius decreases significantly, and can be categorized in to two regions, one is controlled by laminar molecular diffusion followed the other controlled by turbulent entrainment. The variation of flame spread rate (FSR) with wire configuration and metal core thermal conduction are well interpreted by a theoretical model, which describes the heat recirculation through flame-insulation-core comprehensively based on thermodynamics theories, and attempts to consider the effects of temperature gap between core and insulation at pyrolysis front, burning fraction and melting heat. The validity of this new model is well confirmed by measured FSR. An important finding is that a highly conductive core will trigger an acceleration of FSR over the wire, primarily because heat flux in gas phase is more sensitive to the change of core thermal conductivity than heat conduction through core. Even though the heat diffusion length increases at the same time, however, the heat flux in gas phase grows faster than the corresponding heat loss through core, thereby compensate the corresponding heat loss. This work could facilitate understanding of heat transfer mechanism and burning behavior not only on the electrical wires, but also on the composite material with high thermal-conductive media.

Ignition and Flame Spread over Thermal Aging Electrical Wires in Subatmospheric Pressure

Electrical Treeing Behavior of DC and Thermally Aged Polyethylenes Utilizing Wire-Plane Electrode Geometries

The Effect of DC Electro-thermal Ageing on Electrical Treeing in Polyethylene

Influence of Thermal Aging on Insulation Properties of Voltage Stabilizer Blended Cross-Linked Polyethylene

PE and ETFE Wire Insulation Flame Morphologies and Spread Rates under Subatmospheric Pressures

Investigation on Thermal Aging and Degradation of XLPE for High Voltage Cable Applications

Flame-Retardant Wire Burning Behavior by Jet Flame Heating: Ignition, Charring, and Secondary Flame Spread

Experimental Study on the Thermoplastic Dripping and Flame Spread Behaviors of Energized Electrical Wire under Reduced Atmospheric Pressure

An Experimental Study on Flame Spread over Electrical Wire with High Conductivity Copper Core and Controlling Heat Transfer Mechanism under Sub-Atmospheric Pressures

Effect of Thermal Aging on the Physicochemical Structure of XLPE Cable Insulation

Research on combustion characteristics and fire risk of ZR-BVR wires with different thermal aging degrees

Experimental study on polyethylene insulation wire dripping phenomenon under sub-atmospheric pressure

Flammability degradation behavior and ageing mechanism of flame-retardant cable sheath under different ageing conditions

Effect of Thermal Ageing on Insulation Properties of 500 Kv DC XLPE Submarine Cable Insulation

The Effects of Angular Orientation and Ultraviolet Aging on ETFE Wire Flame Spread

Analysis of Upward- and Downward Flame Spread over Vertical Installed Polyethylene-Insulated Electrical Wires

Effects of Thermal Aging on the Crystal Structures of the XLPE Cable Insulating Material at Different Temperatures

Ignition and Flame Propagation of Externally Heated Electrical Wires with Electric Currents

Study on melting characteristics of crystals in thermal aged XLPE cable insulation at elevated temperature

Ignition and Flame Spreading Features of Excessively Overloaded Polyvinyl Chloride Copper Wires

Different Oxygen Diffusion Patterns in XLPE under Thermal Oxidative Aging