Effects of Confined Distance Near Floor and Wire Size on Electrical Wire Flame Spread Behaviors Based on Heat Transfer
Xinjie Huang,Meng Zhang,Hailong Ding,Peng Xu,Xinyi Zhang,Xinyi Li,Miaomiao Wang,Pengyuan Zhang
DOI: https://doi.org/10.1016/j.ijthermalsci.2024.109173
IF: 4.779
2024-01-01
International Journal of Thermal Sciences
Abstract:This paper aims to investigate the confined distance near the floor(0 similar to 28 mm) and wire size (the ratios of copper core diameter to entire wire diameter are: 6mm/8 mm,6mm/10 mm, 8mm/12 mm and 6mm/12 mm for type I, type II, type III and type IV, respectively) on the flame spread over polyethylene (PE) wires. It is indicated that, when the confined distance is relatively small, the extinction occurs for all types. The typical parameters of flame shape including of flame width, flame height and flame area, flame spread rate and mass loss rate with the increase of confined distance s can be separated into continuous growth stage and stable fluctuation stage. At the continuous growth stage, the flame area shows an exponential relationship with s as: A similar to s(5/2). And at the stable fluctuation stage, the flame width is larger than that at the unconfined condition accounting for a large portion. While, the flame height is always smaller than that in the unconfined case. In order to explicitly describe the heat transfer, the upward large main flame and downward small flame are firstly introduced in this paper. Correspondingly, the heat flux feedback of components to the preheating zone is established with the upward main flame flux (q) over dot(f)''((up)) [includes of (q) over dot(vf(up))'' + (q) over dot(rf(up))''], the downward small flame heat flux (q) over dot(f(down))'' [includes of (q) over dot(vf) (down)) ''+ (q) over dot(rf(down))''], the conductive heat flux (q) over dot(c)'' and the gypsum board heat flux (q) over dot(g)''. With the increase of s, q(f(down))'' shows an increasing and then decreasing trend, making it take a second role during heat flux feedback. Meanwhile, the analysis demonstrates that for the larger copper core (type III) and the smaller of PE thickness (type I), the ratio of heat flux of (q) over dot(f(down))/(q) over dot(f(up)) +(q) over dot(f(down)) will be increased, which will enhance the heat transfer effect of downward small flame.