Abstract:CsSnI(3) is an unusual perovskite that undergoes complex displacive and reconstructive phase transitions and exhibits near-infrared emission at room temperature. Experimental and theoretical studies of CsSnI(3) have been limited by the lack of detailed crystal structure characterization and chemical instability. Here we describe the synthesis of pure polymorphic crystals, the preparation of large crack-/bubble-free ingots, the refined single-crystal structures, and temperature-dependent charge transport and optical properties of CsSnI(3), coupled with ab initio first-principles density functional theory (DFT) calculations. In situ temperature-dependent single-crystal and synchrotron powder X-ray diffraction studies reveal the origin of polymorphous phase transitions of CsSnI(3). The black orthorhombic form of CsSnI(3) demonstrates one of the largest volumetric thermal expansion coefficients for inorganic solids. Electrical conductivity, Hall effect, and thermopower measurements on it show p-type metallic behavior with low carrier density, despite the optical band gap of 1.3 eV. Hall effect measurements of the black orthorhombic perovskite phase of CsSnI(3) indicate that it is a p-type direct band gap semiconductor with carrier concentration at room temperature of ∼ 10(17) cm(-3) and a hole mobility of ∼585 cm(2) V(-1) s(-1). The hole mobility is one of the highest observed among p-type semiconductors with comparable band gaps. Its powders exhibit a strong room-temperature near-IR emission spectrum at 950 nm. Remarkably, the values of the electrical conductivity and photoluminescence intensity increase with heat treatment. The DFT calculations show that the screened-exchange local density approximation-derived band gap agrees well with the experimentally measured band gap. Calculations of the formation energy of defects strongly suggest that the electrical and light emission properties possibly result from Sn defects in the crystal structure, which arise intrinsically. Thus, although stoichiometric CsSnI(3) is a semiconductor, the material is prone to intrinsic defects associated with Sn vacancies. This creates highly mobile holes which cause the materials to appear metallic.

ChemInform Abstract: CsSnI3: Semiconductor or Metal? High Electrical Conductivity and Strong Near‐Infrared Photoluminescence from a Single Material. High Hole Mobility and Phase‐Transitions.

CsSnI3: Semiconductor or Metal? High Electrical Conductivity and Strong Near-Infrared Photoluminescence from a Single Material. High Hole Mobility and Phase-Transitions.

First-principles thermodynamics of CsSnI3

Structural Stability, Vibrational Properties, and Photoluminescence in CsSnI3 Perovskite upon the Addition of SnF2

Ultrasmall Blueshift of Near-Infrared Fluorescence in Phase-Stable Cs2SnI6 Thin Films

Surface phase diagram of CsSnI$_3$ from first-principles calculations

Impressive optoelectronic and thermoelectric properties of two-dimensional XI$_2$ (X=Sn, Si): a first principle study

First-principles study of the surface energies and electronic structures of γ-CsSnI 3 surfaces

Ligand-mediated synthesis of colloidal Cs2SnI6 three-dimensional nanocrystals and two-dimensional nanoplatelets

First-principles calculation for phonon and optoelectronic properties of CsSnI3

Structural, elastic, electronic, bonding, and optical properties of topological CaSn3 semimetal

First Principles Analysis of Crystal Structure, Electronic and Optical Properties of CsSnI3–xBrx Perovskite for Photoelectric Applications

ChemInform Abstract: Cs2MIIMIV3Q8 (Q: S, Se, Te): An Extensive Family of Layered Semiconductors with Diverse Band Gaps.

Single-source, solvent-free, room temperature deposition of black $γ$-CsSnI$_3$ films

Energy barrier at the N719-dye/CsSnI 3 interface for photogenerated holes in dye-sensitized solar cells

First‐Principles Calculations to Investigate the Ground State, Mechanical Stability, Electronic Structure, and Optical Properties of Tl2SnX3 (X = S, Se, Te)

Indium Doping of Lead-Free Perovskite Cs2SnI6

SnCN 2 : A Carbodiimide with an Innovative Approach for Energy Storage Systems and Phosphors in Modern LED Technology

Synthesis, Crystal Structure and Green Luminescence in Zero-Dimensional Tin Halide (C 8 H 14 N 2 ) 2 SnBr 6

Phase Stability and Defect Physics of a Ternary ZnSnN(2) Semiconductor: First Principles Insights.

ChemInform Abstract: CsHgInS3: A New Quaternary Semiconductor for Γ‐ray Detection.