Abstract:In consideration of the environmental degradation and global scarcity of coking coal resource, substituting coke with coal and improving the gas utilization are the developing trends of ironmaking technology. Oxygen blast furnace, an ironmaking technology with top gas recycling, is most likely to be used in large-scale industrial manufacture considering its advantages of high productivity, high pulverized coal injection rate, low coke rate, high top gas calorific value, etc. The purpose of this paper is to make a little contribution to this technology on burden descending behavior in the metallurgical process. The results would provide reference for the design and operation of oxygen blast furnace. In the complex metallurgical processes with countercurrent multi-phase reactions, solid material motion plays important roles in the process since it determines the path and the residence time of the solid reactants as well as the stress distribution. The continuum model is often employed in the kinetic process analysis for its simplicity and low computational load. In this study, a viscous flow model based on the Navier-Stokes equation was developed to investigate the behavior of solid flow in oxygen blast furnace. A. three dimensional experimental apparatus was constructed to observe burden descending behavior. According to concerned experimental results, it show that the interaction between the burden and the wall is not significant in shaft zone of the furnace. The descending burden maintains initial pattern until it reaches the lower part where the size of the cross section starts to reduce and the strong friction appears obviously in the tracked materials. Consequently, slip boundary condition with the Fanning equation was used for computations to describe the friction between solid flow and the wall or the dead zone. In addition, the position and the gas flow rate of the upper tuyeres were investigated. It was demonstrated that if the upper tuyeres are higher than the top of the belly, the position will strongly influence the solid flow distribution. Thus, gas velocity must be limited in a proper range to keep the solid flow falling down smoothly. By analysis of various solid viscosities, it is shown that solid flow patterns are not sensitive to solid viscosity within certain range.

DEM Simulation of Layer Formation of Granular Materials in Blast Furnace Burden Distribution

VFM-based Modelling of Burden Descent under Varying Burden Charging Matrix for Blast Furnace

Simulation of the Transfer Process in the Blast Furnace Shaft with Layered Burden

A Comparative Study of the Performance of Different Particle Models in Simulating Particle Charging and Burden Distribution in a Blast Furnace Within the DEM Framework

Numerical Investigation of Burden Distribution in A Blast Furnace

Model-Based Analysis Of Factors Affecting The Burden Layer Structure In The Blast Furnace Shaft

Measurement and Simulation Validation of DEM Parameters of Pellet, Sinter and Coke Particles

Discrete Element Simulation of Flow Pattern of Burden and Distribution of Force Chains in Blast Furnace

DEM Simulation of Burden Circumferential Distribution of Blast Furnace with Parallel Hoppers

Numerical Investigation of Burden Distribution in Ironmaking Blast Furnace

CFD-DEM Study on the Synergistic Effect of Coke Consumption and Particle Dynamics in the Blast Furnace Raceway

Reliability Study of Super-Ellipsoid DEM in Representing the Packing Structure of Blast Furnace

Numerical Simulation Of Burden Descending Behavior In Oxygen Blast Furnace

A review of burden distribution models of blast furnace

Transient Behavior of Burden Descending and Influence of Cohesive Zone Shape on Solid Flow and Stress Distribution in Blast Furnace by Discrete Element Method

DEM simulation of powder phase movement in coke packed bed generated by scanning particles of a blast furnace

DEM Study of the Porosity Distribution of Sinter and Coke Layers in the Throat Region of a Blast Furnace

Influence of Control of the Lower Zone on Burden Motion in Blast Furnace by DEM

Modeling of Blast Furnace with Layered Cohesive Zone

DEM Simulation of Burden Distribution in the Upper Part of COREX Shaft Furnace

Development Of Blast Furnace Burden Distribution Process Modeling And Control