Green Semiconductor Vertical-Cavity Surface-Emitting Lasers Based on Quantum Dots
Baoping Zhang,Yang Mei,Rongbin Xu,Zhiwei Zheng,Hao Long,Leiying Ying
DOI: https://doi.org/10.11605/cp.nmc2017.01062
2017-01-01
Abstract:View Online Nano-Micro Conf., 2017, 1, 01062 | 1 Published by Nature Research Society http://nrs.org Green Semiconductor Vertical-Cavity Surface-Emitting Lasers based on Quantum Dots Baoping Zhang,* Yang Mei, Rongbin Xu, Zhiwei Zheng, Hao Long, Leiying Ying Department of Electronic Engineering, Optoelectronics Engineering Research Center, Xiamen University, Xiamen, Fujian 361005, China Corresponding Author. Email: bzhang@xmu.edu.cn Received: 20 May 2017, Accepted: 10 June 2017, Published Online: 30 October 2017 Citation Information: Baoping Zhang, Yang Mei, Rongbin Xu, Zhiwei Zheng, Hao Long, Leiying Ying, Nano-Micro Conference, 2017, 1, 01062 doi: 10.11605/ cp.nmc2017.01062 Abstract Green VCSELs emitting in the spectral range from 491.8 nm to 565.7 nm, covering most of the ‘green gap’, are demonstrated. These devices are featured with low threshold current and CW lasing at room temperature. A few technologies such as laser liftoff of sapphire substrate, the removal of high-defect GaN buffer and Cu plating to increase the heat dissipation. Two dielectric DBRs were adopted as the cavity mirrors. The results presented here open up opportunities to design and fabricate semiconductor green lasers with excellent performance that may lead to wide-gamut, low consumption power and compact displays and projectors. The VCSELs could also be bonded on to Si for integration with other optoelectronic devices/circuits.Green VCSELs emitting in the spectral range from 491.8 nm to 565.7 nm, covering most of the ‘green gap’, are demonstrated. These devices are featured with low threshold current and CW lasing at room temperature. A few technologies such as laser liftoff of sapphire substrate, the removal of high-defect GaN buffer and Cu plating to increase the heat dissipation. Two dielectric DBRs were adopted as the cavity mirrors. The results presented here open up opportunities to design and fabricate semiconductor green lasers with excellent performance that may lead to wide-gamut, low consumption power and compact displays and projectors. The VCSELs could also be bonded on to Si for integration with other optoelectronic devices/circuits. References [1] Y. Mei; G. E. Weng; B. P. Zhang; J. P. Liu; W. Hofmann; L. Y. Ying; J. Y. Zhang; Z. C. Li; H. Yang; H. C. Kuo, Quantum dot vertical-cavity surface-emitting lasers covering the ‘green gap’. Light: Science & Applications. 6, e16199 (2017). doi:10.1038/lsa.2016.199 Open Access This article is licensed under a Creative Commons Attribution 4.0 International License. © The Author(s) 2017 Figure 1. Lasing spectra (left) in this work and comparison (right) of threshold currents with literatures.