Abstract:The fluctuating lift on a rectangular cylinder induced by turbulent flow is investigated by force measurement experiments. A square uniform grid is installed downstream of the entrance of the working section of the wind tunnel to generate approximately homogeneous and isotropic turbulence. The rectangular cylinder models of two different cross sections (width to depth ratio B/D = 5, 10) are tested in the experiments. Each rectangular cross section has two aspect ratios (length to width ratio θ = 1, 7) and a fixed width (B = 0.15 m). The measurements include the spectra of fluctuating lift force and vertical turbulent velocity component. From these measurements, the experimental values of generalized transfer functions of these rectangular cylinder models are obtained, which are compared with the calculated values based on three aerodynamic force theories. The one-wavenumber transfer functions and the spanwise influence terms of these rectangular cylinders are used in the calculations, which were determined by the pressure measurement experiments in the previous work. Comparisons of the measured and calculated values of generalized transfer functions demonstrate that the three-dimensional theory is satisfactory and confirm that the one-wavenumber transfer functions and spanwise influence terms determined by the pressure measurements are valid. The results also show that both the two-dimensional theory and the strip theory would overestimate the generalized transfer function, but for the rectangular cylinder with the larger aspect ratio, the strip theory is very close to the three-dimensional theory. The one-wavenumber transfer functions of these rectangular cylinders are therefore determined based on the strip theory. This indicates that the approximate approach to determination of the one-wavenumber transfer function, which was proposed for an airfoil in the previous work, could also be applicable to bluff bodies.

Exploring Feasibility of a Small-scale Wind Tunnel with Rectangular Section Suitable for Experiments on Wall Turbulent Flow

Development of a large recirculating boundary-layer wind tunnel

Constrained Large-Eddy Simulation of Turbulent Flow over Inhomogeneous Rough Surfaces

Air flow quality analysis of an open-circuit boundary layer wind tunnel and comparison with a closed-circuit wind tunnel

Measurements of fluctuating lift forces on rectangular cylinders in turbulent flow

Accurately predicting turbulent heat transfer over rough walls: a review of measurement equipment and methods

Wind Tunnel Experimental Simulation of Downburst Outflow Based on Wall Jet Model

Wall Boundary Conditions for RANS Modelling of Unidirectional and Oscillatory Boundary-Layer Flows

Experimental Investigation of Flow Drag and Turbulence Intensity of A Channel Flow with Rough Walls

Design and testing of an affordable desktop wind tunnel

Design and fabrication of a wind tunnel for building aerodynamics

A new atmospheric boundary layer wind tunnel simulation methodology for wind effects on large cooling towers considering wind environment variations

Effect of near-wall treatments on airflow simulations

Accessibility Study of a Compact Wind Tunnel with an Unequal Spacing Grid for the Outdoor Wind Environment

Fundamentals of Wind-Tunnel Design

Experimental and numerical analysis of a new wind tunnel for building and mechanical ventilation components performance assessment

Design and Research for the Large-Caliber Low-Speed Straight-Flow Wind Tunnel Test Platform

A systematic study of turbulent heat transfer over rough walls

Design and Evaluation of a Flow Capturing Device for a High-Speed Wind Tunnel

Experimental and numerical investigation of turbulent wake flow around wall-mounted square cylinder of aspect ratio 2

A Computational Fluid Dynamic Study for Temperature Uniformity at a Wind Tunnel Outlet with Effects of Heat Transfer along Tunnel Walls