Abstract:This paper presents a high-performance and synthesizable asynchronous pipeline (HPSAP). First, a 4-phase pipeline controlled by the relative-timing (RT) controller is designed. The controller is small (7 gates) and its handshake protocol is highly concurrent, resulting in fewer component delays in cycle time. However, the RT pipeline’s throughput is limited by the inherent reset phase in the 4-phase protocol. Thus, the variant HPSAP pipeline is proposed with the quasi-2phase conversion method. Unlike other existing solutions which aimed at reducing the reset time of the 4-phase protocol, this method imitates the behavior of the 2-phase pipeline and re-activates the reset edge by two steps: 1) replacing all delay-matched units with the maximum delay; 2) adding a small pulse generator on each RT controller. The post-layout HSPICE simulation of a 4-bit 10-stage HPSAP first-in-first-out (FIFO) pipeline indicated a throughput of 5.382 giga data item per second (GDI/s) under SMIC 55nm CMOS technology, which was 77.5% and 14.65% higher than the Click pipeline and Mousetrap pipeline. In the pipeline with processing, a $32\times 32$ bits multiplier was built, and the maximum working frequency of the HPSAP multiplier was faster than Mousetrap and the synchronous counterparts.

Research and Implementation of 32-Bit Maximum Rate Pipelined Adder

Research on application of pipeline technology based on FPGA

8×8 Bit Pipelined Dadda Multiplier in CMOS

Design of Hardware Pipelining Processor

A standard cell automated layout for a CMOS 50 MHz 8*8 bit pipelined parallel Dadda multiplier

Implementation of Pipelined Bit-parallel Adders

Design and Implementation of a 32-Bit Asynchronous Adder

Design and Implementation of Dynamic Pipeline for L32 Embedded Processor

The Implementation of 1-Ghz Bit-Stream Adder Used in Signal Processing in a 0.18-&Amp;#x03bc;m CMOS Technology

Pipelined Carry Look-Ahead Adder

HPSAP: A High-Performance and Synthesizable Asynchronous Pipeline With Quasi-2phase Conversion Method

Research and Implementation of Parallel Prefix Adder

Performance effects of pipeline architecture on an FPGA-based binary32 floating point multiplier

Design of a CPL-Based Pipeline Multiplier Accumulator for 32-Bit CPU

A VLSI Design of a Pipelining and Area-Efficient Reed-Solomon Decoder

Design of the Pipeline for 32-Bit CISC Microprocessor

An Improved FIPS Algorithm for Pipeline Structure and Its Implementation

Optimization Design Of A Full Asynchronous Pipeline Circuit Based On Null Convention Logic

Research of High-Speed Pipelined Floating-Point Multipfier Design

Critical Path Analysis in Data-Driven Asynchronous Pipelines

Design of A Fully Pipelined Single-Precision Floating-Point Unit