Abstract:Plastic instead of steel technology is one of the important means of automotive lightweighting, which can greatly reduce the weight of the car while ensuring the same performance of the product. For the lightweighting of the automotive all-plastic front-end frame structure, the initial structural design of the front-end frame was carried out by HyperMesh; based on the compromise planning method and entropy weight method, the compromise planning method with weight coefficients was used to unify the planning of each subobjective to obtain the integrated response function, and the minimization of the integrated response function was the objective. The main considerations were the lock limit crash load, the cushion area load, and the pedestrian protection impact load under typical operating conditions, the shape optimization, and topology optimization, respectively. The mass of the sheet metal front-end frame was reduced from the original 10.5 kg to 6.8 kg—a weight reduction of 35.24%. The front-end frame was extracted and the mid-plane was repaired by HyperMesh, the complete mid-plane was meshed, loads and properties were added to the mesh, the front-end frame was subjected to static and modal analysis in the OptiStruct module, and the stiffness and intrinsic frequency were verified. The results show that the smallest first-order mode in the modal analysis is 57.38 Hz, which is much larger than the 30 Hz required before design. The fatigue analysis of the front-end frame was then performed using N-code to derive the damage results; it is concluded that its life is 6122 s, much larger than the specified 1200 s. Through the verification of the relevant resonance test, it is judged that the performance of the test part meets the actual requirements comprehensively by checking the status after the test.

Frame Optimization Design Based on Improved Grey Relational Analysis

Optimization Design of Vehicle Frame Based on the Linear Beam Model

Optimization design and analysis of mobile pump truck frame using response surface methodology

Strength Analysis and Improvement of a Heavy-Duty Truck Frame

Lightweight design of truck frame

Optimization of Baja Racing Car Frame Based on GA/MOGA/SA Algorithm and Experimental Research on Bending-torsional Stiffness of Frame

Analysis and optimization of the front subframe of vehicle

Performance-Based Design Optimization of Steel Braced Frame Using an Efficient Discrete Algorithm

Optimization Design of Stamping Manipulator Frame Based on ANSYS Workbench

Design Optimization of the S-frame to Improve Crashworthiness

Optimized Lightweight Frame for Intelligent New-energy Vehicles

Design and Optimization of Retractable Frame for High Flow Water Supply and Drainage Truck

Optimazation Method for a Mini Electric Vehicle Frame Structure

The Modal Analysis and Optimization of an Automobile Frame Body

Structural Optimization of Motorcycle Frame

Integrated method for intelligent structural design of steel frames based on optimization and machine learning algorithm

Optimized Simulation Method And Experimental Verification On Dynamic Analysis Of A Light Truck Frame

Structural analysis and optimization of bicycle frame designs

Optimization Design of Tractor Frame Based on Topological Optimization Method

Optimizing the design of automotive S-rail using grey relational analysis coupled with grey entropy measurement to improve crashworthiness

Research on the Optimization of Automobile Plastic Front Frame Structure