Abstract:Soft magnetic materials with high magnetic susceptibility in response to the influence of alternating magnetic fields, generate an inductive electric voltage in the receiving coil, the spectrum of which contains higher harmonics. This is due to the nonlinear dependence of magnetization on the magnetic field, and the amplitudes of higher harmonics make a significant contribution to the overall signal if an external field leads to magnetic saturation. Magnetic susceptibility and saturation field are largely determined by magnetoelastic interactions in amorphous ferromagnets, respectively, the amplitudes of higher harmonics should depend on external mechanical stresses. In this work, we study the processes of magnetization reversal in amorphous microwires of two compositions: Co 71 Fe 5 B 11 Si 10 Cr 3 and Co 66.6 Fe 4.28 B 11.51 Si 14.48 Ni 1.44 Mo 1.69 under the action of external tensile stresses. For the first composition, mechanical stresses exceeding a certain limit (higher than 350 MPa) lead to the transformation of the magnetic hysteresis from a bistable type to an inclined one. In this case, a sharp change of the harmonic spectrum is observed. In microwires of the second composition with an initially inclined loop, external stresses cause a monotonous increase in the slope of the hysteresis loop (a decrease in susceptibility). In this case, the amplitudes of higher harmonics change significantly at low stresses, lower than 100 MPa. The results were obtained by magnetization reversal of microwire samples using a system of flat coils, which demonstrates the potential of using these materials as wireless sensors of mechanical stresses with remote reading.

Sensors Development Using Its Unusual Properties of Fe/Co-based Amorphous Soft Magnetic Wire

Giant Magnetoimpedance Effect in a Co-Based Microwire for Quick-Response Magnetic Sensor Applications

A New Magnetic Sensor Based on Giant Magneto- impedance Effect of Fe-based Amorphous Wire

A Soft Ferromagnetic Multiwire-Based Inductance Coil Sensor For Sensing Applications

A soft magnetic wire for sensor applications

Correlation of Magnetic Domains, Microstructure and Gmi Effect of Joule-Annealed Melt-Extracted Co68.15fe4.35si12.25b13.75nb1cu0.5 Microwires for Double Functional Sensors

Soft Magnetic Amorphous Microwires for Stress and Temperature Sensory Applications

A novel Co-based amorphous magnetic field sensor

Design and characteristic analysis of giant magnetoimpedance sensor in Fe-based nanocrystalline ribbons

Evolution of the Magnetic Anisotropy and Magnetostriction in Co-based Amorphous Alloys Microwires Due to Current Annealing and Stress -Sensory Applications

Cryogenic Joule Annealing Induced Large Magnetic Field Response Of Co-Based Microwires For Giant Magneto-Impedance Sensor Applications

Novel Magnetic Microwires-Embedded Composites for Structural Health Monitoring Applications

Giant Stress Impedance Magnetoelastic Sensors Employing Soft Magnetic Amorphous Ribbons

Co-Based Magnetic Microwire and Field-Tunable Multifunctional Macro-Composites

Comparative Study on Magnetic Properties and Microstructure of As-prepared and Alternating Current Joule Annealed Wires

Functional Study of Fluxgate Sensors with Amorphous Wires Cores

Surface microstructural design to improve mechanical and giant magneto-impedance properties of melt-extracted CoFe-based amorphous wires

Ferromagnetic Microwires Enabled Polymer Composites for Sensing Applications

Design of Gmi Micro-Magnetic Sensor Based on Co-Based Amorphous Alloys for Space Applications

Stress-Dependent Magnetization Processes in Cobalt-Based Amorphous Microwires