Numerical and experimental study on axial hydroforging process of 5A03 aluminium alloy S-shaped bellows

Qingfeng Wang,Guannan Chu,Lei Sun,Chen Ling,Xiehan Liu

DOI: https://doi.org/10.1007/s00170-023-11816-0

IF: 3.563

2023-01-01

The International Journal of Advanced Manufacturing Technology

Abstract:To overcome the difficulties of forming S-shaped bellows by conventional hydroforming, such as excessive thinning and high internal pressure, and to obtain S-shaped aluminium alloy bellows with large diameters and large expansion rates with minimal reduction in wall thickness, the axial hydroforging method was proposed. In this method, the deformation area produced bending deformation and gradually fitted the die by the end axial feeding under the support of the internal pressure. First, a finite element model was created to investigate the effect of initial internal pressure, final forming internal pressure and axial feeding on the forming quality of 5A03 aluminium alloy S-shaped bellows after springback from the wall thinning ratio and profile accuracy. The results demonstrated that the overall wall thickness of bellows decreased significantly during the bulging and forming stages, whereas the local thickening of the convolution crown occurred during the forging stage, which caused a shift in the position of the maximum wall thinning ratio and a decrease in the wall thinning ratio. The increase in the initial internal pressure increased the maximum wall thinning ratio, convolution height and convolution pitch of the bellows and decreased the convolution thickness. The increase in the final forming internal pressure increased the maximum wall thinning ratio and convolution height of the bellows and decreased the convolution thickness and convolution pitch. The increase in axial feeding increased the convolution height of the bellows and decreased the maximum wall thinning ratio, convolution thickness and convolution pitch. Finally, the experimental setup was designed, and the S-shaped bellows with a small wall thinning ratio and high profile accuracy were successfully manufactured based on the best simulation parameters, which verified the accuracy of the finite element model and the feasibility of the axial hydroforging process. It is essential to develop the bellow hydroforming technology and improve the quality of S-shaped bellows.