Abstract:Considering the abundance of iron and manganese within the Earth's crust, the cathode O3-NaFe0.5Mn0.5O2 has shown great potential for large-scale energy storage. Following the strategy of introducing specific heteroelements to optimize the structural stability for energy storage, the work has obtained an O3-type NaFe0.4Mn0.49Cu0.1Zr0.01O2 that exhibits enhanced electrochemical performance and air stability. It displays an initial reversible capacity of 147.5 mAh g–1 at 0.1C between 2 and 4.1 V, a capacity retention ratio exceeding 69.6% after 100 cycles at 0.2C, and a discharge capacity of 70.8 mAh g–1 at a high rate of 5C, which is superior to that of O3-NaFe0.5Mn0.5O2. The codoping of Cu/Zr reserves the layered O3 structure and enlarges the interlayer spacing, promoting the diffusion of Na+. In addition, the structural stability and air stability observed by Cu-doping is well maintained via the incorporation of extra Zr favoring a highly reversible phase conversion process. Thus, this work has demonstrated an efficient strategy for developing cobalt/nickel-free high-capacity and air-stable cathodes for sodium-ion batteries.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c12684.Rietveld refinement for the XRD pattern of NFMC-0.1 cathode sample; SEM imaging for all the codoped cathode samples, SEM imaging for three cathode samples treated by water immersion; the cyclic curves and the charge–discharge profiles for the codoped cathode samples; the initial charge–discharge curves of NFMCZ-0.01 in different voltage ranges; in situ XRD patterns of NFMCZ-0.01; charge–discharge curves for the three cathode samples after water immersion treatment; the survey spectrum for the codoped cathode sample NFMCZ-0.01 (Figures S1–S8); refined crystal parameters for NFM, NFMC-0.1, and NFMCZ-0.01 by single-phase simulation; comparison of cyclic stability between the previous relevant literature and this work (Tables S1–S4); and detailed procedure to make GITT analysis (PDF)This article has not yet been cited by other publications.

Optimizing Electrochemical Performance in Sodium-Ion Batteries Using O3-type Na0.90Cu0.22Fe0.30Mn0.48O2 and Hard Carbon

Zero-strain Co-doped Na2FeP2O7/carbon Delivers Superior Rate Capability and Long-Cycle Stability for Sodium Ion Batteries

High-Entropy Layered Oxide Cathode Materials with Moderated Interlayer Spacing and Enhanced Kinetics for Sodium-Ion Batteries

Synthesis and Electrochemical Investigation of O3-Type High-nickel NCM Cathodes for Sodium-ion Batteries

Topography Control and Component Design Strategies to Enhance Electrochemical Performance of O3-Type Cathode Materials for Sodium-ion Batteries

P2/O3 biphasic Fe/Mn-based layered oxide cathode with ultrahigh capacity and great cyclability for sodium ion batteries

Coupling Fe3O4/Fe1-xS@Carbon with Carbon-Coated MoS2 Nanosheets As a Superior Anode for Sodium-Ion Batteries

Cu-Doped Spherical P2-Type Na0.7Fe0.23-xCuxMn0.77O2 Cathode for High-Performance Sodium-Ion Batteries.

Sodium Storage Property and Mechanism of NaCr1/4Fe1/4Ni1/4Ti1/4O2 Cathode at Various Cut-off Voltages

Regulating the electrochemical activity of Fe-Mn-Cu-based layer oxides as cathode materials for high-performance Na-ion battery

High Performance Sodium-Ion Full Battery Based on One-Dimensional Nanostructures: the Case of Na0.44MnO2 Cathode and MoS2 Anode

Investigating the Electrochemical Performance of MnFe2O4@xC Nanocomposites as Anode Materials for Sodium-Ion Batteries

Cu-Doped Spherical P2-Type Na0.7Fe0.23- xCu x Mn0.77O2 Cathode for High-Performance Sodium-Ion Batteries

In-situ X-ray studies of high-entropy layered oxide cathode for sodium-ion batteries

A Stable Layered Oxide Cathode Material for High‐Performance Sodium‐Ion Battery

Improving Oxygen‐Redox‐Active Layered Oxide Cathodes for Sodium‐Ion Batteries Through Crystal Facet Modulation and Fluorinated Interfacial Engineering

A Cobalt and Nickel Co-Modified Layered P2-Na2/3Mn1/2Fe1/2O2 with Excellent Cycle Stability for High-Energy Density Sodium-Ion Batteries

Coupled Carbonization Strategy towards Advanced Hard Carbon for High Energy Sodium-Ion Battery.

Copper and Zirconium Codoped O3-Type Sodium Iron and Manganese Oxide as the Cobalt/Nickel-Free High-Capacity and Air-Stable Cathode for Sodium-Ion Batteries

Design of Cu-Substituted O3-Type NaFe0.5 Mn0.5 O2 Cathode Materials for Sodium-Ion Batteries