Abstract:With the increasing requirements for aircraft assembly accuracy, pre-assembly analysis technology based on measured data has become one of the most important process precision compensation methods. How to accurately obtain and analyze the measured data of key features of parts according to assembly intention is the key step of pre-assembly analysis technology. Existing researches only explain the importance of the correct selection of measurement datum qualitatively, but none of them analyzed theoretically and provided specific methods when the measurement datum is inconsistent with the design datum, which is easy to misjudge the originally qualified parts. Therefore, this paper proposes a novel assembly-oriented measurement datum transformation and tolerance reallocation method for aircraft assembly. Firstly, based on the assembly type and geometric feature classification, the measurement datum of parts without Geometric Dimensioning and Tolerancing (GD&T) is identified, and the importance of correct selection of measurement datum is proved by a case theoretically. Secondly, when the measurement datum is not coincident with the assembly datum, a spatial homogeneous transformation method of measured data is proposed, which transforms the measured data from a temporary measurement coordinate system (TMCS) to an assembly datum coordinate system (ADCS). Finally, the tolerance redistribution of the measurement target features relative to the TMCS is carried out directly on the basis of the original tolerance. The experimental results show that the key features exceeding the upper tolerance limit of 0.042 mm are within the theoretical tolerance again after datum transformation, which solves the problem that the part has been misjudged as unqualified in the measurement process.

Measurement Process and Its Express of Geometry Features in Missile Assembly

Assembly Accuracy Analysis for Small Components with A Planar Surface in Large-Scale Metrology

Approach to the measurement information modeling of product in manufacture procedure

Measurement of deformed surface and key data processing based on reverse engineering

An Imperfection Measurement System for Thin-Shell Structures Based on a Laser Displacement Meter

Realistic Geometry Based Feature Modeling of Complex Part and Its Application in Assembly Quality Analysis

GEOMETRIC DESIGN OF DEPLOYABLE/RETRACTABLE MAST

Configuration Analysis Of The Ers Points In Large-Volume Metrology System

Measurement technologies for precision positioning

Registration Error Analysis and Evaluation in Large-Volume Metrology System

Pose Measurement and Assembly of Spacecraft Components Based on Assembly Features and a Consistent Coordinate System

Research on the assembly method of missile based on laser scanning

A generic approach for analysis of mechanical assembly

Medium and Far Range Ground-to-Air Missile System Effectiveness Evaluation Model

Tolerance analysis method for feasibility of assembly

Analysis and Measurement of Flatness of a Single-Layer Deployable Truss Structure Driven by Elastic Components

Application of Monte Carlo Method in the Measurement Process Design According to Next Generation of Gps

A novel assembly-oriented measurement datum transformation and tolerance reallocation method

A Modeling Method of Complex Assembly Based on Digital Twin

Research on General Assembly Modeling Supporting Product Lifecycle Engineering Design

A Modeling Method for Process Systems and Studies on the Dynamical Behavior