Abstract:The Laboratory for Advanced Simulation of Turbulence (LAST) at Tsinghua University had been working on turbulence modeling for almost two decades. Previous work includes the nonlinear eddy-viscosity model satisfying the realizability condition, the BGK gas kinetic scheme, the numerical simulation of supersonic mixing layers, etc. Recently, the modeling work had been concentrated on compressible turbulent flows and supersonic/hypersonic boundary layer flow transition. This presentation is thus focused on the latter two topics. Compressibility is well known to suppress turbulence, the cause of the compressibility effects remains, however, unclear. Previous studies carried out in the early 1990s conjectured that the main compressible effects were associated with the dilatations of velocity fluctuation. Later, it was shown that the main compressibility effect came from the reduced pressure-strain term due to reduced pressure fluctuations. Although better understanding of the compressible turbulence had generally been achieved with the increased DNS and experimental efforts, there are still some discrepancies among these recent findings. In the present work the effect of compressibility on shear flows are characterized in three categories corresponding to three regions of turbulent Mach numbers Mt: the low-Mt, the transition-Mt and the high-Mt regions. It is observed in these three regions that the effect of compressibility on the growth rate of the turbulent mixing layer is rather different. A simplified approach to model the reduced pressure-strain effect may not necessarily reduce the mixing-layer growth rate, rather, an increase in the growth rate may occur. The present work develops a new second-moment model for the compressible turbulence through the introduction of some blending functions of Mt to account for the compressibility effects on the flow. The model has successfully applied to the compressible mixing layers. In the supersonic/hypersonic boundary layer flow transitions, it is known that the most unstable mode, over certain range of Mach number, differs from the traditional incompressible case. The second or even higher unstable modes can occur and dominate the instability of the flow, hence, influencing the flow transition to turbulence. The present work takes the second instability mode into modeling consideration, a new transition model is proposed which shows reasonably good performance in high speed, as well as in slow speed, flow transitions.

Compressible Correction for Separated and Shear Flow Based on Structural Compressibility

Effects of compressibility correction onγ-Reθ transition model

Validation and Analyses of QCR Correction Turbulence Model in Sub-/Super-sonic Inner Flows

Assessment of the shear-improved Smagorinsky model in laminar-turbulent transitional channel flow

Application of simplified threeGequation transition model in hypersonic flow

Simulation of Couette Flow Using Conventional Burnett Equations with Modified Slip Boundary Conditions

Computation of Hypersonic Transitional Flows Over Cones Using Gas-Kinetic Scheme Coupled with the Turbulence Model

AN EXTENDED K-Ε MODEL FOR NUMERICAL SIMULATION OF WIND FLOW AROUND BUILDINGS

Assessment of Compressibility Corrections on Spalart–Allmaras Turbulence Model for High-Mach-Number Flows

Viscous-Layer Compressibility Correction for Two-Equation Reynolds-Averaged Navier–Stokes Models

Compressible effects modeling for turbulent cavitating flow in a small venturi channel: An empirical turbulent eddy viscosity correction

Model of Interfacial Term in Turbulent Kinetic Energy Equation and Computation of Dissipation Rate for Particle-Laden Flows

A new non‐equilibrium modification of the k−ω turbulence model for supersonic turbulent flows with transverse jet

An Improved Second‐Moment Closure Model for Langmuir Turbulence Conditions: Model Derivation and Validation

Prediction of transonic film cooling using the turbulent viscosity correction method

Comparison Study on Different Compressibility Modifications of Turbulence Model in Supersonic Combustion Simulation

Modelling the Compressibility Effect with Second-Moment Closure

Computation of Hypersonic Turbulent and Transitional Flows Using an Extended Gas Kinetic Scheme

Variable-property and intrinsic compressibility corrections for turbulence models using near-wall scaling theories

Accuracy and Stability Enhancements in the Incompressible Finite-Volume-particle Method for Multiphase Flow Simulations.

Modelling of Turbulent Flows at LAST, Tsinghua University