Abstract:This study conducted plane-strain scaled model tests to investigate the deformation characteristics of geosynthetic reinforced soil (GRS) abutments subjected to vertical loads. Setback distance, i.e., the distance between the back of the abutment facing and the front of the loading plate, was chosen as the investigated influencing factor since it is one of the most frequently used variables by engineers for the design of GRS abutments. This study analyzed the settlements at the top of the abutment, the lateral displacements of the abutment facing, and the volumetric deformation of the abutment under the applied vertical loads. Test results showed that increasing the setback distance could effectively reduce the deformations of the GRS abutment. There existed an optimum setback distance and further increasing the setback distance beyond this optimum value did not have a significant effect on reducing the abutment deformations. The vertical, lateral, and total volumetric deformations of the GRS abutment showed an approximately linear increase with the increase of the applied vertical loads. The lateral volumetric deformations of the GRS abutment were larger than its vertical volumetric deformations and therefore the total volumetric strains of the GRS abutment were not zero based on the test results. However, the theory of zero volume change may still be suitable for the deformation calculation of the GRS abutment since the values of the volumetric strains were minimal. The measured maximum lateral facing displacements were compared with the calculated values using the US Federal Highway Administration (FHWA) method, which assumes zero volume change of the GRS abutment under vertical loads. Comparison results indicated that the FHWA method overestimated the maximum lateral facing displacements of the GRS abutment under vertical loads. An improved method was proposed in this study to calculate the maximum lateral facing displacements under vertical loads based on the theory of zero volume change and a revised distribution of the settlements at the top of the GRS abutment. Results showed that the improved method could better predict the maximum lateral facing displacements as compared to the FHWA method.

Research on Centrifugal Model Test of Bridge Abutment Backfilling

CENTRIFUGAL MODEL TESTS ON HYDRAULIC HEAVE MECHANISM OF EXCAVATION IN COHESIVE SOIL WITH CONFINED WATER

BACK-ANALYSIS OF VISCO-ELASTIC PARAMETERS OF FILLING MATERIALS AND SETTLEMENT PREDICTION FOR HIGH-FILLED EMBANKMENT

Model test of abutment on soft soil retaining EPS composite soil

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

Reduction Of Earth Pressure And Displacement Of Abutment With Reinforcement Filling

The Earth Pressure Behind Full-Height Frame Integral Abutments Supporting Granular Fill

Performance of Deep Braced Excavation under Embankment Surcharge Load

Subsoil stiffness effects on the bridge-abutment dynamic behaviour

Centrifuge Study on Behavior of Rigid Pile Composite Foundation under Embankment in Soft Soil

Laboratory study of the behavior of granular soils behind integral bridge abutments

FIELD SURVEY OF COMPOSITE FOUNDATION WITH RIGID PILES UNDER EMBANKMENT

Analysis of the Deep-Seated Concrete Slab for Settlement Control at Bridge Approach Embankment

Mitigation of seasonal temperature change-induced problems with integral bridge abutments using EPS foam and geogrid

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Predicting the Earth Pressure on Integral Bridge Abutments

Numerical analysis on the performance of a cushioned foundation with a mixture of both rigid and flexible piles

MECHANICAL BEHAVIOR OF REINFORCED EMBANKMENT CONSIDERING INTERACTION BETWEEN GRAVEL AND GEOCELL

Case Study of the Deep-Seated Concrete Slab for Settlement Control at Bridge Approach Embankment

Behaviour of piled bridge abutments on soft ground: A design method proposal based on 2D elasto-plastic-consolidation coupled FEM

Scaled Model Tests Investigating Deformation Characteristics of Geosynthetic Reinforced Soil (GRS) Abutments under Vertical Loads