Abstract:Accurate measurement of the downwash flow field of plant protection unmanned aerial vehicles (UAVs) is essential for analyzing the spatial distribution of droplets. To realize on-line rapid detection of the downwash flow field of a multi-rotor UAV, a flexible polypropylene detection device based on the principle of full bridge strain effect was proposed. Its performance principle was based on the physical deformation caused by wind pressure. The Fluid Flow and Static Structural modules of ANSYS 16.0 finite element software were used to simulate one-way fluid-solid coupling interaction. The surface of the resistive strain gauge embedded in the flexible detecting structure responded well to wind speed variation, hence it was suitable for downwash airflow wind field detection. By solving the strain force on the surface of the flexible detection structure, the length and layout of the grating wire of the strain gauge on the surface of the flexible detection structure were optimized. Meanwhile at 4 m·s−1 wind speed, the output voltage at varied bridge flexible acquisition systems in the acquisition card was measured. Results indicated coefficient of variation of 3.67%, 1.63% and 1.5%, respectively, which proved the good data acquisition consistency of the system. Through calibration test, the regression equation for the relationship between output voltage and wind speed for three unique sensor signal measuring circuits was established. The determination coefficients R2 for single bridge, half bridge and full bridge circuits were 0.9885, 0.9866 and 0.9959, respectively. In conclusion, by applying the multi-rotor plant protection UAV test platform, the results indicated the maximum relative error of the wind speed at each sampling point of the system at 1.0 m altitude was below 5.61%. Simulated and measured value had an RMSE maximum error of 0.1246 m·s−1. Moreover, downwash airflow detection not only has high accuracy but also has high sensitivity. Thus, there is convenience and practicability in the plant protection offered by this approach. The rapid measurement of UAV wind field and the established two-dimensional wind field model can provide a basis for precise application of agricultural aviation.

A Compact Embedded Flight Parameter Detection System for Small Soaring UAVs

Development of a Low-Cost AOA/AOS Sensor and Data Processing System for Small-Sized UAVs

Towards Virtual Testing of Flapping Flight

A Miniature Integrated Navigation System for Rotary-Wing Unmanned Aerial Vehicles

The Use of Physical Restraint in Patients with Cerebral Contusion

Bioinspired Dynamic Soaring Simulation System with Distributed Pressure Sensors.

Estimation of Airspeed, Angle of Attack, and Sideslip for Small Unmanned Aerial Vehicles (UAVs) Using a Micro-Pitot Tube

Flexible Skin for Measurement of Boundary Layer State and Flight Attitude Identification on UAV

Wind Speed Measurement by an Inexpensive and Lightweight Thermal Anemometer on a Small UAV

Calculation And Identification Of The Aerodynamic Parameters For Small-Scaled Fixed-Wing Uavs

Aircraft flight parameter detection based on a neural network using multiple hot-film flow speed sensors

Compact Sphere-Shaped Airflow Vector Sensor Based on MEMS Differential Pressure Sensors

Remote Sensing on a Bird-inspired Flapping Wings Robot Combined with LiDAR

Wind Gust Detection using Physical Sensors in Quadcopters

Design of UAV Downwash Airflow Field Detection System Based on Strain Effect Principle

Design and testing of a crop growth sensor aboard a fixed-wing unmanned aerial vehicle

Designing of Airspeed Measurement Method for UAVs Based on MEMS Pressure Sensors

Online Parameter Estimation for Fixed-Wing UAV Based on DREM Method and Adaptive Control

Flexible Micro Flow Sensor for Micro Aerial Vehicles

Artificial Hair Sensor Placement Optimization on Airfoils for Angle of Attack Prediction

DOB-based Wind Estimation of A UAV Using Its Onboard Sensor