Abstract:This paper analyzes the microstructure and electrical insulation characteristics at the interface of 500 kV cross-linked polyethylene (XLPE) cable factory joints for extra high voltage direct current (EHVDC) application. The interface between two layers was polished by different grit sandpapers (80, 400, 1000, 2000, and 0000 (unpolished)). The samples (#1000) polished by 1000 grit mesh at the interface were degassed at 70 degrees C for 0, 12, 36, 90, and 200 h, respectively. Physico-chemical and electrical experiments were performed on the prepared test samples. It is found that increasing the number of sandpaper grit meshes reduces the average lamellae thickness at the interface and increases the crystallinity. Moreover, microporous defects are observed at the interface. The parameters viz elongation at break, current density, and the number of microporous defects increase initially and then decrease. However, the space charge accumulation, threshold electric field strength, and DC breakdown decrease initially and then increase. Notably, the #1000 roughness is a turning point. On the other side, degassing treatment promotes the orderly folding and recrystallization of the molecular chains arranged the amorphous region and significantly reduces the microporous defects at the interface. The mechanical properties are affected to a certain extent. The improved microstructure reduces the space charge accumulation and the current density of the sample, and increases the DC breakdown strength. An interfacial microscopic model and a charge transport model are proposed to analyze the mechanism of material properties under different roughnesses and electric fields. The results indicate that the ultra-smooth interface and degassing treatment strengthen the molecular chain linking at the interface. Moreover, they significantly reduce the microporous defects at the interface and improve the insulation properties of the factory joint. (C) 2021 Elsevier Ltd. All rights reserved.

The Evaluation of the Buffer Layer Chemical Corrosion for HV XLPE Insulated Cable with Corrugated Aluminium Sheath Structure

Study on Ablation Between Metal Sheath and Buffer Layer of High Voltage XLPE Insulated Power Cable

Analysis on Buffer Layer Discharges below the Corrugated Aluminum Sheath of XLPE Cables and Comparison with Other Metal Sheath Structures

AC corrosion analysis of the buffer layer in HV corrugated-aluminum sheathed power cables

Study on the Ablation Process and Failure Mechanism of the Buffer Layer in High-Voltage XLPE Cable

Failure Investigation of Buffer Layers in High-Voltage XLPE Cables

Study on the Current Concentration and Local Heating of the Buffer Layer in HV XLPE Cables

Analysis for Metal Sheath Corrosion Rate in AC High Voltage Power Cable

Effect of Tensile Stress on Insulation Properties of 500 Kv EHVAC XLPE Cable under Multi-Field Ageing

Investigation on Thermal Aging and Degradation of XLPE for High Voltage Cable Applications

Interfacial Microstructure and Insulation Properties of 500 Kv EHVDC XLPE Cable Factory Joint under Different Roughness and Degassing Durations

Effects of Connection Conditions Between Insulation Screen and Al Sheath on the Buffer Layer Failures of High-Voltage XLPE Cables

Analysis of Influencing Factors on Buffer Layer Discharge for High‐voltage XLPE Cable

Analysis of Discharge Defect in Buffer Layer for Highvoltage Cable and Rejuvenation Method

Influence of Aluminum Sheath Structure on Floating Potential of XLPE Insulation Shielding Layer

Gas production analysis for the buffer layer of high‐voltage cross‐linked polyethylene cables

Mechanism of Status Evaluation for Water Blocking Buffer Layer of High Voltage Cable Based on Characteristic Gas Analysis

Research on the Impact Mechanism of Electric Field to the Waterproof Buffer Layer in HV Power Cables

Hydrogen evolution and electromigration in the corrosion of aluminium metal sheath inside high‐voltage cables

The Formation Mechanism of White Substances on Water-blocking Buffer Layer of HV XLPE Cables

Experiments on the ultrasonic detection of buffer layer ablation defects in high-voltage cables