Abstract:The widely use of covered conductor increases the reliability of distribution network. However, a new problem of partial discharge caused by covered conductor at the position of tower head is generated at the same time. This kind of partial discharge will damage the insulation layer or accelerate the deterioration of insulation, which may cause the single-phase grounding fault and affect the power supply reliability. At present, there is few systematic studies on the characteristics of this partial discharge. This paper mainly analyzes the electric field distribution near the covered conductor around tower head, builds the partial discharge experiment platform, and obtains the pulse current characteristics of partial discharge under different working conditions. The results show that the maximum electric field intensity is located at the interface between covered conductor, binding wire and air. The main causes of partial discharge are the wet and dirty of the surface of porcelain insulator and conductor insulation. The minor cause is the breakage of covered conductor insulation. Under different conditions, the initial partial discharge pulse current wave front time is 8ns ~ 45ns, the tail time is 30ns ~ 150ns. The discharge time interval can be as low as $30~\mu \text{s}$ . In addition, it is found that there are two types of partial discharge through spectral analysis. One occurs when the covered conductor insulation is damaged under binding wire; the other is the covered conductor insulation is intact.

Study on the Influence of 10kV Insulator and Metal Binding Wire Form on Partial Discharge in Distribution Network

Research on Lightning Protection of 220kv Substation with Long Cable Inlet Wire

Experimental Study of Protection Measures for Preventing 10 KV Insulated Conductors from Breakage Caused by Lightning Stroke

Study on Lightning Protection Hardware Against Lightning-Caused Breaking of Insulation-Covered Conductors in 10 Kv Overhead Distribution Networks

Characteristics of Partial Discharge on 10 Kv Covered Conductor Around Tower Head

Simulation and Partial Discharge Detection for Typical Defects of 10 Kv Cable the Joint

Study Of The Influence Of Void Defect Size On Partial Discharge Characteristics In Solid Insulation

Study on electrical properties and field solutions of water related heating of composite insulators on 500kV AC transmission lines

Studies on electric field distribution and partial discharges of XLPE cable at DC voltage

Dielectric loss and partial discharge test analysis of 10 kV XLPE cable

Study on Discharge of Grading Rings for Insulators in the 500 Kv Gangcheng Substation

Study on High Temperature Heating Characteristics of Degraded Composite Insulators

Typical Defect Simulation of 110kv Cable and Its Partial Discharge Characteristic Test

Simulation of Composite Insulator Interface Defects in Partial Discharge

Study On The Effect Of Inner Discharge On Temperature Distribution In Power Cable Terminal

The Degradation of 10kv XLPE Cable Accessories under Switching Impulses

Study on the voltage-sharing performance of porcelain insulators on 750kV compact double circuit transmission line

Partial Discharge Characteristics in the Course of Aging Within XLPE Insulation

Research On The Influence Of Different Defects Upon Gis Disconnector Electric Field Distribution

Simulation and Test of Potential Distribution for 750 kV Insulator String

The Relationship Between Partial Discharge Behavior and the Degradation of 10 Kv Xlpe Cable Joints