Insights into the So2 Poisoning Mechanism over Copper Ion Exchanged Zeolite for Nh3-Scr: Experiment and Dft Calculation

Xiaoyong Jiang,Jie Yang,Ya Liang,Handan Zhang,Yuanqi Zhou,Shan Ren,Qingcai Liu,Lu Yao,Weizao Liu
DOI: https://doi.org/10.2139/ssrn.4348235
2023-01-01
Abstract:Selective catalytic reduction with NH3 is an efficient technology for NOx emissions reduction. In this study, copper ion exchanged zeolite catalysts (Cu-X) were prepared from blast furnace slag. Cu-X showed excellent catalytic activity and SO2 tolerance with 84% NO conversion in the presence of 50 ppm SO2. According to the in-situ DRIFTS study of the transient reaction and the adsorption performance of reaction gases and SO2 on γ-Cu-X catalyst, excessive Cu inhibited the SO2 chemisorption on the active site of zeolite X to some extent. DFT kinetic adsorption simulation module was used to simulate the adsorption of gas components on γ -Cu-X catalyst and the transition state of active center. The results showed that the amount of Cu in the adsorption system affected the average local chemical potential during the reaction process, leading to the change of the adsorption heat of SO2 gas in the component of γ-Cu-X catalyst, and the change of the load of SO2 in the Cu-X catalyst cell. In addition, increasing exchanged capacity of Cu can affect the distribution of bridged hydroxyl (Si-OH-Al), terminal hydroxyl (SiOH) and Cun+-L, and the reaction paths and barriers of SO2 chemisorption in each active center were different, leading to different sulfur resistance.
What problem does this paper attempt to address?