Numerical simulation of heat transfer characteristics of falling-film evaporation of R32/R134a non-azeotropic refrigerant outside a horizontal tube
Qifan Wang,Xuetao Liu,Minxia Li,Dandan Su,Chaobin Dang
DOI: https://doi.org/10.1016/j.icheatmasstransfer.2023.107001
IF: 6.782
2023-09-22
International Communications in Heat and Mass Transfer
Abstract:In response to the restrictions of the international community on the utilization of refrigerants with high GWP, the replacement of high-GWP refrigerants with non-azeotropic refrigerants and reduction in refrigerant charge have gradually become important research topics in academia. In this study, based on the VOF method, a 2D model of a sheet flow pattern was developed by considering the thermophysical properties and multicomponent phase change of a mixture. The falling-film evaporation of a non-azeotropic refrigerant composed of R32 and R134a outside a horizontal tube was numerically simulated. The effects of the spray height ( H ), tube diameter ( d ), inlet temperature ( T inlet ), Reynolds number ( Re ), heat flux ( q ), and mass fraction of R32 in the liquid-phase mixture ( M R32_liquid ) on the heat transfer coefficient ( HTC ) were studied. The results indicate that with the increase of circumferential angle ( Φ ), the local HTC exhibits a trend of decreasing, increasing, decreasing, and increasing in sequence. The largest contribution to the increase in the average HTC comes from the impact and fully developed regions. An increase in H , T inlet , and M R32_liquid is beneficial to the expansion of the fully developed region, whereas a decrease in d leads to expansion of the fully developed region. An increase in Re does not affect the extent of the fully developed region. The increase in H , Re , T inlet , and M R32_liquid increases the average HTC , but the effect of T inlet is not significant. Under the conditions of d = 24 mm, H = 13 mm, Re = 4000, M R32_liquid = 0.5, and q = 10 kW/m 2 , as the inlet temperature increases from 243.15 K to 283.15 K, the average HTC increases by 2.5%. An increase in q does not affect the average HTC , whereas an increase in d does not improve the average HTC .
thermodynamics,mechanics