Abstract:The major challenge for wireless power transfer (WPT) is to extend transfer distance and to broaden transfer direction, while a stable power can be transferred with high and constant efficiency. The multi-coil WPT system can transfer power on the plane or space omnidirectionally, but its output power and efficiency are usually difficult to keep stability. For a nonlinear wireless power transfer system based on parity-time (PT) symmetry, when the coupling condition of the system can be satisfied, it can attain a stable power with high and constant efficiency, but it still has a dead-spot problem in the transfer direction. Therefore, this article proposes a design of a plane-omnidirectional WPT system, of which the coupling condition can be maintained across the plane. The transmitter coils are a pair of orthogonal coils which are named transmitter coils 1 and 2. Meanwhile, in the transmitting circuit, the positive direction of transmitter coil 1, which determines the positive direction of current and flux, is controlled by a reversed switch group (RSG) with a logic-check loop (LCL). Moreover, the theoretical analysis shows that the proposed system can reverse the flux direction of transmitter coil 1 while the angle of transfer direction is overly large, then the coupling condition of the system after reversal can still be satisfied. Finally, the experimental results show that when the receiver coil moves around the transmitter coils on the whole plane, the stable output power of 14 W is maintained with an approximately constant transfer efficiency of 87%.

Crossed Dipole Coils for Omnidirectional Simultaneous Wireless Power and Data Transfer System Functioning with Full-Duplex Communication

A New Simultaneous Wireless Power and Information Transfer System with Integrated Signal Magnetic Coupler.

Basic Principles of Point-to-Point Omnidirectional Wireless Power Transfer System

A Simultaneous Wireless Power Transfer and Data Transfer System With High Misalignment Tolerance

A Simultaneous Wireless Power and Data Transfer System with Decoupled Double-Channel Power and Single-Channel Data Coils

A Novel Dual-Transmitted Wireless Power Transfer With High Lateral Misalignment Tolerance

A Wireless Power Transfer CPS Based on 2D Omni-directional Rotating Magnetic Field

A Decoupled Power and Data-Parallel Transmission Method with Four-Quadrant Misalignment Tolerance for Wireless Power Transfer Systems

Omnidirectional Free-Degree Wireless Power Transfer System Based on Magnetic Dipole Coils for Multiple Receivers

A FDM-based Simultaneous Wireless Power and Data Transfer (SWPDT) System Functioning with High-rate Full-duplex Communication

High-Efficiency Omnidirectional Wireless Power Transfer System

A High-Misalignment-Tolerant and Extensive Vertical Adaptation Combined Simultaneous Transmission of Power and Data for WPT System

Power Stability Analysis of Three-Phase Omnidirectional Wireless Power Transfer System Based on Tripolar Pad

A 3-D Rotating Magnetic Field Modulation Method for Omnidirectional Wireless Power Transfer Systems

Simultaneous Wireless Power and Data Transfer System With Single Coil Based on Multifrequency Modulation

Omnidirectional Wireless Power Transfer System Supporting Mobile Devices

Design and Analysis of an Omnidirectional Dual-Band Wireless Power Transfer System

A Novel Simultaneous Wireless Power and Data Transfer Scheme for Two-stage Inductive Power Transfer Systems

Plane-Omnidirectional Wireless Power Transfer System Based on Vector-Controlled Flux Linkage

Wireless Power and Data Transfer Via a Common Inductive Link Using Frequency Division Multiplexing

Omnidirectional Wireless Power Transfer System with a Multidirectional Receiver Inside a Cubic Transmitter.