Synthesis and Structure Stabilization of Disordered Rock Salt Mn/V-Based Oxyfluorides As Cathode Materials for Li-Ion Batteries

Iris Blumenhofer,Yasaman Shirazi Moghadam,Abdel El Kharbachi,Yang Hu,Kai Wang,Maximilian Fichtner
DOI: https://doi.org/10.1021/acsmaterialsau.2c00064
2022-01-01
ACS Materials Au
Abstract:The demand for high-performance lithium-ion batteries and thus efficient cathode materials is steadily increasing. In addition to a high energy density and long lifetime, these should also be cost-effective and environmentally benign. Manganesebased materials have particular potential because manganese is available in sufficient quantities and can be supplied at a comparatively low cost. Hence, in this study, manganese-based disordered rock salt oxyfluorides Li(2)Mn(1-x)VxO(2)F (0 <= x <= 0.5) are synthesized as cathode materials for lithium-ion batteries using high-energy mechanochemical ball-milling. The effect of partial vanadium substitution on the sample properties is analyzed, focusing on the electrochemical properties. Furthermore, a heat treatment process for stabilization of the samples is followed, where the morphology and structure of the samples are studied by powder X-ray diffraction and electron microscopy (SEM/TEM). The oxidation states of the transition metals in the synthesized compositions are further investigated using X-ray absorption nearedge structure spectroscopy. The data analysis reveals that the heat treatment resulted in increased symmetry and reduced defects of ball-milled compounds, but it may also affect the local fluorination degree in the structure. However, the results show that this treatment process has a beneficial effect on capacity retention of the formulated electrodes (similar to 81% after 100 cycles), a faster response to the change of cycling rate, and less increase in charge-transfer resistance of the samples during cycling. Such a structural improvement attributed to mitigation of the surface/bulk defects is an additional input to the series of cathode candidates of low temperature stability.
What problem does this paper attempt to address?