Abstract:In order to realize the acquisition and storage of underwater acoustic signals for aiming at the requirements of multi-channel, low power consumption and small volume for underwater receiver extension of sonar system, a multi-channel signal acquisition and storage system based on FPGA and STM32 with variable number of working channels and sampling frequency is designed, in which the system is consisted of 8 pieces, 8 channel and 24 bits high dynamic range Δ-Σ ADS1278 ADC chip to synchronous multi-channel analog signal acquisition. FPGA, as the acquisition sequence and logic control, reads and collates the ADC chip data and writes it into the internal high-capacity FIFO, and adds corresponding operations according to the characteristics of FIFO in an application. SMT32 single-chip microcomputer reads the FIFO data through the high-speed SPI interface with FPGA and writes the multi-channel data into the high-capacity SD card. The testing results have verified that the system has characteristics such as stable and reliable, easy configuration, low power consumption, can guarantee the multichannel data serial transmission, storage, accurate, up to 64 analog signals at the same time the real-time collection and storage, top 20 kHz sampling rate, the system total power of the system of about 3W, data rates up to 100 Mb/s, fully meet the needs of underwater sound acquisition system.

Ultrasonic Transceiver Circuit Design

Transmitting Circuit Design for Ultrasonic Transducer

Analysis of OFDM modulation method and experiment for acoustic transmission system along drill strings

Study of Ultrasonic Transmiting System Based on DDS

Research and design of ultrasonic Doppler flowmeter hardware system based on STM32

Design on the experiment device of ultrasonic telemeter digital circuit

Design of Vibrating Wire Sensor Signal Acquisition Board Based on STM32

Design of Four-channel Ultrasonic Flowmeter Transceiver Circuit

Design of Intelligent Ultrasonic Power Source Based on FPGA

Design and Implementation of Ultrasonic Transducer Detection System Based on STM32

A Circuit for Transmiting/receiving Ultrasonic Pulse Based on the 80C196MC

Transmitting and receiving circuit for two-channel high-frequency ultrasonic probe

Design of ultrasonic distance measurement system based on STM32 microprocessor

Design and Realizatiom of Receiver Based on Eastimation of Acoustic Target Signal Intensity

The Design of High Frequency Ultrasonic Driver Circuit Based on AD9832

Investigation to Dual-Frequency Direct Digital Synthesis and Resonance Frequency Tracking in Power Ultrasonic Generator

Design of Ultrasonic Processing Circuits in Borehole Sediment Thickness Measurement

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Research on Low-Frequency Remote Programmable Sound Source System

A Low Cost And High Performance Design Of X-Band Short Range Doppler Radar Transceiver

Multi-Channel Data Acquisition System Based on FPGA and STM32