Abstract:The performance of superconducting magnets is greatly dependent on the size and uniformity of the superconducting filaments within the wire. However, in the fabrication of Bi 2 Sr 2 CaCu 2 O x (Bi2212) wires using ceramic oxide as the superconducting filaments, we face multiple challenges including filament fragility, poor uniformity, and non-smooth Ag/superconductor interfaces. These challenges primarily stem from the significantly lower plastic deformation capability of ceramic oxide powder filaments compared to metal matrices. To address these challenges, this study focuses on the modification of ceramic oxide precursor powders. Through the utilization of low-temperature, low oxygen partial pressure ( p O 2 ) heat treatment, we have observed significant changes in the Cu chemical states and lattice parameters within the Bi2212 grains. These alterations have proven to be highly effective in reducing the energy required for grain sliding and, in turn, enhancing the plastic deformation properties of the Bi2212 oxide filament. Furthermore, post-annealing the oxide powder under low p O 2 conditions narrows the gap in plastic deformability between the Ag sheath and the oxide filaments, resulting in improved filament uniformity and a smoother Ag/oxide interface in Bi2212 wires. Notably, the Bi2212 grains exhibit an orderly arrangement within the wires. As a result of these improvements, the critical current density ( J c ) of the final wires increases by an impressive 70 %. The outcomes of this study are not only crucial for producing Bi2212 magnets with higher magnetic field strength, improved magnetic field uniformity, and enhanced operational stability, but also offer fresh insights and methodologies for advancing the field of superconducting materials.

Damage Behavior in Bi-2212 Round Wire with 3D Elastoplastic Peridynamic

Influence of Torsional Strain on the Bi-2212 Tapes and Round Wires under Background Field

Microstructure and Critical Current Density of Bi-2212 Single- and Multi-filamentary Wires with Overpressure Heat Treatment Processing

Strain dependence of critical current and self-field AC loss in Bi-2223/Ag multi-filamentary HTS tapes: a general predictive model

Micromechanical modelling on the elastoplastic damage and irreversible critical current degradation of the twisted multi-filamentary Nb3Sn superconducting strand

Density dependent constitutive model for Bi-2212 powder compression deformation

Relating Residual Stress and Microstructure to Mechanical and Giant Magneto-Impedance Properties in Cold-Drawn Co-based Amorphous Microwires

Study on Performance Degradation of Multi-Layer Spiral Superconducting Cable Under Bending Load

Role of internal gases and creep of Ag in controlling the critical current density of Ag-sheathed Bi2Sr2CaCu2Ox wires

X-ray microtomography analysis of the damage mechanisms in 3D circular braided carbon fiber/epoxy resin composite tubes under axial impact compression

Simultaneous determination of diphenhydramine, methaqualone, diazepam and chlorpromazine in liver by use of enzyme digestion: a comparison of digestion procedures.

Evidence for length-dependent wire expansion, filament dedensification and consequent degradation of critical current density in Ag-alloy sheathed Bi-2212 wires

Development of persistent joints for superconducting Bi-2212 coils

Improvement of plastic deformation property and current carrying capacity of Bi2212 wires through low oxygen partial pressure post-annealing of precursor

Deformation Behaviors of Multi-Filamentary Superconducting Wire with Elliptical Section During Rolling

Revealing the effect of bridges in the multi-filamentary Bi-2212 wires

Initial damage influence of stiffness reduction for bronze route Nb3Sn strands

Mechanical Properties of Concentric Three-Phase HTS Cable Based on Laminated Theory

Intertwined effects of elastic deformation and damage on vortex pinning and Jc degradation in polycrystalline superconductors

New concept for the development of Bi-2212 wires for high field applications

Local Plastic Deformation Effects on the Critical Current of High-Jc Nb3Sn Strands under Uniaxial Strain