Comparison of surface wind pressures and overall wind loads on two types of dry coal sheds

SHEN Guohui,HAN Kanghui,LI Yipeng,JIANG Yonghan

DOI: https://doi.org/10.13465/j.cnki.jvs.2023.08.025

2023-01-01

Abstract:Wind tunnel test was employed to compare the wind pressure distribution and overall wind load of three-centered and bullet-type dry coal sheds.The distribution of shape coefficients of the two types of dry coal sheds under different wind direction was analyzed. Then the testing results were compared with those regulated in various specifications. The overall force coefficients on the two types of dry coal sheds under various wind azimuths were calculated and compared.The overall force coefficients of the middle part and both sides of the bullet-type dry coal shed were given. Studies show that the negative pressure on the windward side of the roof is relatively large when the wind direction is facing the wall, while the negative pressure on the middle and leeward sides is relatively small. The peak negative wind pressures of the two types of dry coal sheds appear near the top of sheds under inclined wind azimuth. When the wind direction is facing the side of the shed, the positive pressure regulated in the GB specification is less than the test values, and the negative pressure regulated in the AIJ and EN specification are higher than the test values.The shape coefficient changes sharply with the angle, therefore the expressions of segmented shape coefficient in the specifications are not reasonable.A fitting equation base on trigonometric function was thereby developed. The lift coefficients of the three-centered dry coal shed are smaller than those of the bullet-type shed with the same rise-span ratio, indicating that the overall averaged wind load of the three-centered shed is smaller than that of the bullet-type shed in the view of design.