Abstract:Aiming at the blockage and wear-off of lifting pump in deep-sea mining transportation system,the fluid field of the lifting pump was solved by the standard κ-ε turbulence model and the particle flow trajectories was simulated with a discrete phase model,and effects of particle diameter, guide vane inlet-stagger-angle and number of guide vanes on the blockage and wear characteristics of lifting pump were investigated. Results showed particles generally collided most frequently with the front cover plate in the first partition of the guide vane,leading to a serious abrasion in this area,and also frequently with the pressure face in the third and fourth partition of guide vane. The collision between particles and guide vane predominantly changed particles trajectory and led to less abrasion on the pressure face of guide vane. With an increase in particle size,both the average time for particles passing through the guide vane and numbers of collision with guide vane were on the rise,which increased the possibility of particles colliding with the suction surface. With the increasing of guide vane inlet-stagger-angle, an average time for particles passing through vanes and average collision numbers were all increased. It is found that the collision of particles with pressure face that is closer to the inlet of the guide vane blade,will lead to more serious abrasion of the inlet of pressure face. With an increase in the guide vane numbers,the time for passing through the vane was shortening. And with the collision of particles with the pressure face of guide vane moving to the center part,the pressure face became less worn off.

Finite element analysis of mixed transport pump in deep-sea mining under complicated conditions

Analysis and Experimental Research on Efficiency Characteristics of a Deep-Sea Hydraulic Power Source

Prediction of Quasi - Fluid Performance in Different Volume Concentration of Deep Sea Mining

CFD-DEM analysis of internal flow characteristics in multistage deep-sea mining pumps

Balance of Efficiency and Security-influence on Slurry Transport from the Diffusion of Flow Passages of a Deep-sea Mining Pump

On the Axial Thrust and Hydraulic Performance of a Multistage Lifting Pump for Deep-Sea Mining

Research on the Unsteady Flow Characteristics of Solid–Liquid Two-Phase Flow in a Deep-Sea Mining Lift Pump and Model Experimental Verification

Numerical calculation and analysis of gas-liquid two-phase flow in a centrifugal multiphase pump for deep-sea mining

Fluid-solid Coupled Dynamical Analysis of Deep-ocean Mining System

A New Lifting Pump for Deep-Sea Mining

Research of Particle Motion in a Two-Stage Slurry Transport Pump for Deep-Ocean Mining by the CFD-DEM Method

Numerical Simulation of Particle Motion Trajectory in Lifting Pump for Deep-sea Mining

Numerical Investigation on the Dynamics of Mixture Transport in Flexible Risers During Deep-Sea Mining

Particle Anti-Accumulation Design at Impeller Suction of Deep-Sea Mining Pump and Evaluation by CFD-DEM Simulation

Study on Fluid Radial Force in Six-Stage Deep-Sea Lifting Pump

Motion characteristics of coarse particles in guide vanes of lifting pump for deep-sea mining

Impact of Particle Sizes on Flow Characteristics of Slurry Pump for Deep-Sea Mining

Design and Analysis of an Innovative Deep-Sea Lifting Motor Pump

Liquid–solid Two-Phase Flow and Wear Characteristics in a Two-Stage Mixed-Transport Pump

Numerical Investigation on Dynamic Performance of Vertical Hydraulic Transport in Deepsea Mining

WATER HAMMER PRESSURE OF HYDRAULIC LIFTING PIPELINE IN DEEP-SEA MINING PILOT SYSTEM