Abstract:Additive Manufacturing (AM) is a process that is based on manufacturing parts layer by layer in order to avoid any geometric limitation in terms of creating the desired design. In the early stages of AM development, the goal was just creating some prototypes to decrease the time of manufacturing assessment. But with metal-based AM, it is now possible to produce end-use parts. In powder-based AM, a designed part can be produced directly from the STL file (Standard Tessellation Language/ stereolithography) layer by layer by exerting a laser beam on a layer of powder with thickness between 20 μm and 100 μm to create a section of the part. The Achilles’ heel of this process is generation of some defects, which weaken the mechanical properties and in some cases, these defects may even lead to part failure under manufacturing. This prevents metal-based AM technology from spreading widely while limiting the repeatability and precision of the process. Online monitoring (OM) and intelligent control, which has been investigated prevalently in contemporary research, presents a feasible solution to the aformentioned issues, insofar as it monitors the generated defects during the process and eliminates them in real-time. In this regard, this paper reveals the most frequent and traceable defects which significantly affect quality matrices of the produced part in powder-based AM, predominately focusing on the Selective Laser Sintering (SLS) process. These defects are classified into “Geometry and Dimensions,” “Surface Quality (Finishing),” “Microstructure” and the defects leading to “Weak Mechanical Properties.” In addition, we introduce and classify the most important parameters, which can be monitored and controlled to avoid those defects. Furthermore, these parameters may be employed in some error handling strategies to remove the generated defects. We also introduce some signatures that can be monitored for adjusting the parameters into their optimum value instead of monitoring the defects directly.

Review of the Categories and Characterization Methods of Defects in Alloy Prepared by Selective Laser Melting

A Review of In Situ Defect Detection and Monitoring Technologies in Selective Laser Melting

A Review of <i>In Situ</i> Defect Detection and Monitoring Technologies in Selective Laser Melting

Quality control: Internal defects formation mechanism of selective laser melting based on laser-powder-melt pool interaction: A review

A review of selective laser melting of aluminum alloys: Processing, microstructure, property and developing trends

A Review of Research of Microstructure and Defects in Ni-Based Superalloys Fabricated by Selective Laser Melting

Characteristics of Metal Specimens Formed by Selective Laser Melting: A State-of-the-Art Review

Formation of Defects in Selective Laser Melted Inconel 718 and Its Correlation with Mechanical Properties Through Dimensionless Numbers

Microstructure evolution during selective laser melting of metallic materials: A review

A review on the simulation of selective laser melting AlSi10Mg

A Review of Research Progress in Selective Laser Melting (SLM)

Review on residual stress in selective laser melting additive manufacturing of alloy parts

Effects of Defects and Microstructures on Tensile Properties of Selective Laser Melted Ti6Al4V Alloys Fabricated in the Optimal Process Zone

Defects, Process Parameters and Signatures for Online Monitoring and Control in Powder-Based Additive Manufacturing

A Review of SLMed Magnesium Alloys: Processing, Properties, Alloying Elements and Postprocessing

In-situ Monitoring and Defect Detection of Selective Laser Melting Process and Impact of Process Parameters on the Quality of Fabricated SS 316L

Defects Control of Aluminum Alloys and Their Composites Fabricated via Laser Powder Bed Fusion: A Review

Additive Manufacturing of Magnesium Alloys by Selective Laser Melting Technology: A Review

A Review and a Statistical Analysis of Porosity in Metals Additively Manufactured by Laser Powder Bed Fusion

In Situ X-ray Micro-Computed Tomography Study of the Damage Evolution of Prefabricated Through-Holes in SLM-Printed AlSi10Mg Alloy under Tension