Abstract:The representative volume element (RVE) established on the mesoscopic scale,by which the analysis can reflect the behavior of materials with complicated microstructures and macroscopic statistical mechanical properties,is an effective method to predict the mechanical properties.These mechanical properties of materials,such as yield or subsequent yield,plastic flow,hardening,damage and failure,are closely related to their stress states and stress state paths.In this paper,the method of simulating a normal hexahedron RVE with fully periodic boundary conditions under arbitrary stress state with arbitrary loading path to calculate the macroscopic stress and strain in the entire course of the loading is theoretically analyzed.Seven springs are added on the RVE to control the load/unload of each stress component in accordance with the prescribed route and state using the relation between the internal force of spring and spring extension.The calculation is performed by using the general purpose finite element software ABAQUS adding a user subroutine (User subroutine to define multi-point constraints,MPC) to keep RVE under specified (constant or arbitrary) stress state path in the entire course of the loading and unloading.To versify this method,the multi-scale analysis of the special positions of notched round bar under cyclic loading is carried out.Through the numerical analysis,it is confirmed that the proposed method can be used to reveal the relationship between material microstructure,deformation failure mechanism and failure criterion and fatigue properties.The results show that:(1) The method enables us to perform RVE calculations under any specified arbitrary stress state and stress state paths (proportional or non-proportional loading) with high computational efficiency and accuracy;(2) The simulation associated with RVE can obtain the microstructure evolution when the macrostructure under complex loading;(3) The result of the RVE model can be used to establish the constitutive equations and further to investigate the influence of stress state and stress state path on the mechanical properties of materials.

Graphical Modeling of Discontinuous Stress Field for RC Deep Beams under Uniform Load

Analytical Theory of Composite Beams with CSWs Using the State Space Method

Shear-Transfer Mechanisms and Strength Modeling of RC Continuous Deep Beams

Elastic-to-Plastic Strut-and-Tie Model for Deep Beams

Simplified Discontinuous Field Model for RC Beams with a Medium Shear Span Ratio: Experimental Study and Shear Strength Formula

Analysis of FEM Cubic Representative Volume Element along Specified Stress Path

Continuous Stress Model for Beams Treated with Active Constrained Layer Damping

Direct Strut-and-tie Model for Single Span and Continuous Deep Beams

Simulations for the behavior of FRC diagonally reinforced coupling beams with small span-to-depth ratio

THE STRESS CACULATION METHOD FOR DEEP BEAMS WITH SHEAR-BENDING COUPLING DISTORTION UNDER CONCENTRATED LOAD

Essential Stressing State Features of a Large-Curvature Continuous Steel Box Girder Bridge Model Revealed by Modeling Experimental Data

Graphical Poly-Arch Model for the Ultimate Limit State Verification of RC Deep Beams under Hanging Loads

A Continuous Stiffness Approach for Modeling Edge-Cracked Beams with Different Cross-Sections Based on Energy Theory

Stressing State Analysis of Reinforced Concrete Beam Strengthened by CFRP Sheet with Anchoring Device

Integrating 3d Stress Analysis With Flexible Multibody Dynamics Simulation

Continuum-based Approach for Modelling the Flexural Behaviour of Plain Concrete Beam under High-Cycle Fatigue Loads

Analytical And Numerical Modeling Of Prestressed Continuous Steel-Concrete Composite Beams

Development of Strut-and-Tie Models Using Load Path in Structural Concrete

A unified modeling strategy of the stability and progressive damage behavior of CFRP double-blade composite stiffened structures (DCSS) under uniaxial compression

Dynamics modeling and analysis of a spatial curved beam with stress stiffening

A Damped Dynamic Finite Difference Approach for Modeling Static Stress–Strain Fields