Abstract:The selective hydrogenation of acetylene has been studied over AgPd and CuPd catalysts. Controlled surface reactions were used to synthesize these bimetallic nanoparticles on both TiO2 and SiO2 supports. Chemisorption measurements of the bimetallic catalysts indicate that Pd prefers to be on the nanoparticle surface with a Cu parent catalyst, while Pd prefers to be subsurface with a Ag parent catalyst. From energy-dispersive X-ray spectroscopy analysis, the composition of the nanoparticles is determined to be more uniform on the SiO2 support compared to that on the TiO2 support. X-ray absorption spectroscopy results indicate that, after reduction, the CuPd bimetallic catalysts have some Pd–Pd bonds, but the average number of Pd–Pd bonds decreases after reaction. Infrared spectra of the adsorbed CO show that an increased fraction of isolated Pd species are present on the bimetallic catalysts compared to those on the monometallic catalysts. Adsorption of acetylene and ethylene, however, indicates adsorbed surface species that require contiguous Pd ensembles. These results suggest that the surface structure of the catalyst is highly dynamic and influenced by the gas environment, as well as the support. The catalysts are active for the selective hydrogenation of acetylene in an ethylene-rich environment under mild conditions. Over all catalysts, the ethylene selectivity is greater than 92%; however, improved selectivity is observed over the bimetallic catalysts compared to that over the monometallic Pd catalysts. An ethylene selectivity of 100% is observed over the CuPd0.08/TiO2 catalyst. The highest acetylene conversion rate per gram of Pd is observed over the CuPd0.02/TiO2 catalyst, while the highest turnover frequency is found over the AgPd0.64/TiO2 catalyst. The bimetallic SiO2-supported catalysts have lower rates than Pd/SiO2 but still show improved selectivity. The combined characterization measurements and reaction kinetics studies indicate that the performance improvements of the bimetallic catalysts may be attributed to both electronic and geometric modifications of Pd by the parent Cu or Ag metal.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.0c01536?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.0c01536</a>.UV–vis spectra during catalyst synthesis, FTIR spectra of TiO2 and SiO2 supports after reaction mixture adsorption, XANES and EXAFS spectra, and reaction time on stream data for acetylene conversion (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.0c01536/suppl_file/cs0c01536_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Preparation of Al2O3 Supported Cu-Based Catalyst and Its Catalytic Performance in Selective Hydrogenation of Acetylene

Improvement of performance of a Au–Cu/AC catalyst using thiol for acetylene hydrochlorination reaction

Copper-Based Catalysts for Selective Hydrogenation of Acetylene Derived from Cu(OH) 2

Preparation of an Unsupported Copper-Based Catalyst for Selective Hydrogenation of Acetylene from Cu 2 O Nanocubes

A Highly Active Catalyst Derived from CuO Particles for Selective Hydrogenation of Acetylene in Large Excess Ethylene

An efficient NiCu@C/Al 2 O 3 catalyst for selective hydrogenation of acetylene

The Cost-Effective Cu-based Catalysts for the Efficient Removal of Acetylene from Ethylene: the Effects of Cu Valence State, Surface Structure and Surface Alloying on the Selectivity and Activity

Promotion of Mg(OH)2 in Cu-Based Catalysts for Selective Hydrogenation of Acetylene

AgPd and CuPd Catalysts for Selective Hydrogenation of Acetylene

Bi-modified Cu-Based Catalysts for Acetylene Hydrogenation: Leveraging Dispersion and Hydrogen Spillover

Atomic Layer Deposited Palladium Nanoparticle Catalysts Supported on Titanium Dioxide Modified MCM-41 for Selective Hydrogenation of Acetylene

Hydrophobic Surface Modification of Cu-Based Catalysts for Enhanced Semihydrogenation of Acetylene in Excess Ethylene

Carbon-confined Cu-Pd alloy nanoparticles as high-performance catalysts for acetylene selective hydrogenation

Improvement of Selectivity in Acetylene Hydrogenation with Comparable Activity over Ordered PdCu Catalysts Induced by Post-treatment

Synthesis of Pd–Ag/Al2O3 catalyst by colloidal oxide method for acetylene selective hydrogenation: a study on the sintering of PdO nanoparticles

Layered Double Hydroxides Derived Zno-Al2o3 Supported Pd-Ag Catalysts for Selective Hydrogenation of Acetylene

Catalytic Properties of Supported Pd/Tio2 and Pd-Ag/Tio2 Catalysts for Selective Hydrogenation of Acetylene

Effects of Supports and Promoter Ag on Pd Catalysts for Selective Hydrogenation of Acetylene

Interfacial Bifunctional Effect Promoted Non-Noble Cu/Fe y MgO x Catalysts for Selective Hydrogenation of Acetylene

Regulating Metal-Support Interactions of Pd/MgAl2O4 for Efficient Selective Hydrogenation of Acetylene

Selective hydrogenation of high concentration acetylene over the well-defined crystalline sites of Pd1Cu1 and Pd1Cu3