Abstract:The effect of the addition of high-octane oxygenated fuel including methyl tertiary butyl ether ( MTBE), ethanol, and methanol on combustion phasing and combustion rate of homogeneous charge compression ignition (HCCI) combustion fueled with n-heptane as base fuel was comparatively investigated. In this paper, n-heptane was blended with MTBE, ethanol, and methanol from 10 vol % to 60 vol % at 10 vol % increments, respectively. Three kinds of blended fuels were injected into intake air, and their premixed HCCI combustions were studied comparatively. The results show that the HCCI combustion fueled with high-octane oxygenated fuel/n-heptane blended fuels is delayed in the combustion phasing and suppressed in combustion rate in contrast to that with pure n-heptane. Given the higher fuel/air equivalence ratio, the combustion phasing of blended fuels is progressively delayed with the increasing proportion of MTBE, ethanol, or methanol, so that the high-temperature heat release (HTHR) can occur near top-dead center (TDC) or later; at the same time, the HCCI combustion can be suppressed to partial burn or even misfire when the proportion of MTBE, ethanol, and methanol is increased to some extent, respectively. On the other hand, MTBE, ethanol, and methanol have some differences in how they affect the n-heptane- fueled HCCI combustion. In view of the capability of delaying combustion phasing, methanol is exhibited as the most powerful of the three fuels and ethanol is stronger than MTBE. In view of suppressing the combustion rate of HCCI combustion, methanol is the most effective and MTBE is the least powerful among the three fuels. When total fueling rate is kept at 18.7 mg/cycle, the misfire of methanol/n-heptane blended fuels occurs near methanol 40 vol % (M40), and that of methanol/n- heptane blended fuels occurs near ethanol 50 vol % ( E50); however, MTBE/n-heptane blended fuels do not misfire till MTBE 60 vol % (MTBE60). The differences among the three fuels fundamentally result from their performance of difficult autoignition. At the same time, the oxygen content in the high-octane oxygenated fuels may improve the HTHR of HCCI combustion that is still suppressed by the addition of these fuels. On the basis of the difference of three high-octane oxygenated fuels in the control of combustion phasing and combustion rate, it is noted that MTBE has more advantages over methanol and ethanol in the potential of extending the operating range of n-heptane- fueled HCCI combustion by adjusting the addition of MTBE, ethanol, and methanol, respectively, at the same total fueling rate.

On Tert-Butyl Hydroperoxide in Ignition Intensification of N-Heptane under Engine-Relevant Condition

Effects of hydrogen peroxide addition on two-stage ignition characteristics of n-heptane/air mixtures

Experimental and Kinetic Study on Di-Tertiary Butyl Peroxide Auto-Ignition and Its Effect on the Ignition of N-Heptane

Mechanism study on the auto-ignition and reaction kinetic characteristics of hydrogen/n-dodecane mixture under mid and high temperature conditions

Effect of Additive on the Heat Release Rate and Emissions of Hcci Combustion Engines Fueled with Ron90 Fuels

Low-Temperature Hypergolic Ignition of 1-Octene with Low Ignition Delay Time.

Synergistic promotion of multi-component RP-3 kerosene low-temperature ignition with addition of radical activator

Effect of Additive on the Ignition, Combustion, and Emissions for HCCI Engine Fueled with High RON Fuels

Effect of Oxygen Content on N-Heptane Auto-Ignition Characteristics in A Hcci Engine

Hydrogen, Methane, Ethylene And Propylene Blending On The Ignition Delay Time Of N-Heptane/Toluene Mixtures Under Homogeneous And Nonpremixed Counterflowing Conditions

Inhibition effect of doping methyl tert-butyl ether compounds to n-heptane on homogenous charge compression ignition combustion

Effect of High-Octane Oxygenated Fuels on N-Heptane-Fueled Hcci Combustion

Experimental and numerical investigation of vitiation effects on the auto-ignition of n-heptane at high temperatures

High-speed Imaging of N-Heptane Ignition in a High-Pressure Shock Tube

Autoignition of Butanol Isomers/n-Heptane Blend Fuels on a Rapid Compression Machine in N 2 /O 2 /ar Mixtures

Impact of Nitric Oxide (NO) on N-Heptane Autoignition in a Rapid Compression Machine

Experimental Study and Chemical Analysis of N-Heptane Homogeneous Charge Compression Ignition Combustion with Port Injection of Reaction Inhibitors

Effect of Injection Timing on the Ignition Process of N-Heptane Spray Flame in a Methane/air Environment

Inhibition of Autoignition and Combustion Rate for N-Heptane Homogeneous Charge Compression Ignition Combustion by Methanol Additive

Multi-component Effect and Reaction Mechanism for Low-Temperature Ignition of Kerosene with Composite Enhancer

Numerical and Experimental Study on 95% Hydrogen Peroxide Catalytic Ignition of Hybrid Rocket Motors with HTPB-based Aluminum Additive Fuel