Abstract:In the concrete preparation 70–80 % occupying natural aggregates like crushed rock and river sand, the most commonly used coarse and fine aggregate is likely become scarcer the it is today. Now construction people need the alternatives to natural aggregates. Therefore, finding alternatives to naturally available materials is important to sustaining construction industry. On other hand a large quantity of waste materials are being produced by various industries and the governments are seeking ways to reduce the problem of disposal and to control the health hazard from the accumulation of waste materials. Some of the waste materials, such as coal fly ash, bottom ash, glass granules, plastic granules, copper slag, and crushed rock dust were used in the concrete. So in such waste materials are used to modify the mechanical and durability properties of concrete so as to make it suitable for any situation, this would also additional benefits in terms of reduction in cost, energy savings, promoting ecological balance and conservation of natural resources. In this study, the production of concrete was obtained by partially replacing the fine aggregate with Crumb rubber. The main advantages of crumb rubber utilization in concrete to give the lower density, higher impact and toughness resistance, enhanced ductility, and better sound insulation etc. Crumb rubber is made by shredding waste tires. In the shredding process the steel wires are removed from the discard tires. The crumb rubber particle size ranging from 0.075 mm to not exceeding 4.75 mm, similar to the fine aggregates. Experimental investigations were carried out to study the behaviour of concrete with and without Crumb rubber. The replacement of crumb rubber contents varying 5–25 % of river sand by volume. The test results indicated that the addition of waste tire crumb rubber substitution increases, the density, Compressive strength and Static modulus of elasticity was decreased. At the same time the Flexural strength was increased up to 15 % of crumb rubber replacement. The relationship between Static modulus of elasticity and Flexural strength with Compressive strength of concrete with and without Crumb rubber was analyzed and compared the experimental results with the empirically calculated values by using design codes.

Fresh and Hardened Properties of Waste Rubber Tires Based Concrete: a State Art of Review

OVERVIEW OF RECYCLING RUBBER TIRE AS AGGREGATES IN CONCRETE: AN APPROACH FOR SOLID WASTE MANAGEMENT

A Review of the Durability-Related Features of Waste Tyre Rubber as a Partial Substitute for Natural Aggregate in Concrete

Rubber/crete: Mechanical properties of scrap to reuse tire-derived rubber in concrete; A review

A comprehensive review on the application of renewable waste tire rubbers and fibers in sustainable concrete

The Use of Recycled Tire Rubber, Crushed Glass, and Crushed Clay Brick in Lightweight Concrete Production: A Review

Strength, durability and shrinkage behaviours of steel fiber reinforced rubberized concrete

Recycling waste rubber tyres in construction materials and associated environmental considerations: A review

Performance analysis and engineering application of waste rubber crumbs in concrete

Mechanical and microstructural characterization of sustainable concrete containing recycled concrete and waste rubber tire fiber

Improved strength performance of rubberized Concrete: Role of ground blast furnace slag and waste glass bottle nanoparticles amalgamation

Thermal and Mechanical Properties of Concrete Incorporating Silica Fume and Waste Rubber Powder

Investigation of the Behaviour of Concrete Containing Waste Tire Crumb Rubber

Mechanical Properties of Rubberised Geopolymer Concrete

Research progress on rubber concrete properties: a review

Fiber-reinforced recycled aggregate concrete with crumb rubber: A state-of-the-art review

Enhancing high-performance concrete sustainability: integration of waste tire rubber for innovation

Eco-friendly concrete with chemically treated end-of-life tires: Mechanical strength, shrinkage, and flexural performance of RC beams

Toward the development of sustainable concrete with Crumb Rubber: Design-oriented Models, Life-Cycle-Assessment and a site application

Effects of Recycled Rubber Particles Incorporated as Partial Sand Replacement on Fresh and Hardened Properties of Cement-Based Concrete: Mechanical, Microstructural and Life Cycle Analyses

Carbonation Depth and Chloride Ion Penetration Properties of Rubberised Concrete Incorporated Ground Blast Furnace Slag