Abstract:A low-cost 1-DOF hand exoskeleton for neuromuscular rehabilitation has been designed and assembled. It consists of a base equipped with a servo motor, an index finger part, and a thumb part, connected through three gears. The index part has a tri-axial load cell and an attached ring to measure the finger force. An admittance control scheme was designed to provide intuitive control and positive force amplification to assist the user's finger movement. To evaluate the effects of different control parameters on neuromuscular re-sponse of the fingers, we created an integrated exoskeleton-hand musculo-skeletal model to virtually simulate and optimize the control loop. The exo-skeleton is controlled by a proportional derivative controller that computes the motor torque to follow a desired joint angle of the index part, which is obtained from inverse kinematics of a virtual end-effector mass driven by the finger force. We conducted parametric simulations of the exoskeleton in action, driven by the user's closing and opening finger motion, with different proportional gains, end-effector masses, and other coefficients. We com-pared the interaction forces between the index finger and the ring in both passive and active modes. The best performing assistive controller can re-duce the force from around 1.45N (in passive mode) to only around 0.52N, more than 64% of reduction. As a result, the muscle activations of the flex-ors and extensors were reduced significantly. We also noted the admittance control scheme is versatile and can also provide resistance (e.g. for strength training) by simply increasing the virtual end-effect mass.

Design and Evaluation of a Low Friction Rigid-Soft Hybrid Mechanism for Hand Exoskeletons with Finite Element Analysis.

Design and Simulation Experiment of Rigid-Flexible Soft Humanoid Finger

Fusing Topology Optimization and Pseudo-Rigid-Body Method for the Development of a Finger Exoskeleton

Design and modeling of a hybrid soft-rigid hand exoskeleton for poststroke rehabilitation

Design of a Compact Finger-Integrated Mechanism with Robust Kinematics for Hand Exoskeleton

Design and Prototyping of an Underactuated Hand Exoskeleton With Fingers Coupled by a Gear-Based Differential

Design and Characterization of a Rolling-Contact Involute Joint and Its Applications in Finger Exoskeletons

Finger Exoskeleton for Rehabilitation of Finger Extension and Flexion by Multi-Segment Mechanism

Developing of A Rigid-Compliant Finger Joint Exoskeleton Using Topology Optimization Method

Mechanism Design and Kinematic Analysis of a Robotic Modular Finger and Reconfigurable Hand

Design and Modeling of a Bioinspired Flexible Finger Exoskeleton for Strength Augmentation

Development and kinematics/statics analysis of rigid-flexible-soft hybrid finger mechanism with standard force sensor

Design and Characterization of a High-performance Wearable Robot Using Symmetric Conjugate Surface Joints

Torsional Stiffness Improvement of a Soft Pneumatic Finger Using Embedded Skeleton

Design Optimization of Soft Robotic Fingers Biologically Inspired by the Fin Ray Effect with Intrinsic Force Sensing

Mechanical design, modeling, and identification for a novel antagonistic variable stiffness dexterous finger

An Attention-Controlled Hand Exoskeleton for the Rehabilitation of Finger Extension and Flexion Using a Rigid-Soft Combined Mechanism

A Soft Wearable Exoskeleton with Pneumatic Actuator for Assisting Upper Limb

Design and Kinematic Optimization of a Novel Underactuated Robotic Hand Exoskeleton

Evaluation of a 1-DOF Hand Exoskeleton for Neuromuscular Rehabilitation

A soft exoskeleton for hand assistive and rehabilitation application using pneumatic actuators with variable stiffness