Room‐Temperature‐Processed, Carbon‐Based Fully Printed Mesoscopic Perovskite Solar Cells with 15% Efficiency

Jian Liu,Dongjie Wang,Yang Zhang,Kun Chen,Bin She,Baichen Liu,Zheling Zhang,Yu Huang,Jian Xiong,Hailiang Zhang,Jian Zhang

DOI: https://doi.org/10.1002/solr.202100274

IF: 9.1726

2021-06-27

Solar RRL

Abstract:<p>Methylamine (MA) and methylamine hydrochloride (MACl) are widely used to prepare highly efficient and stable perovskite solar cells (PSCs). However, MA, as a gas, is difficult to handle and inevitably leads to a large amount of escape, and it is difficult to quantitatively calculate. Here, selecting a mixture solvent of methylamine ethanol solution (MA-EtOH sol) and acetonitrile (ACN) as a solvent, a new strategy for preparing fully printed mesoscopic perovskite solar cells (MPSCs) at room temperature was first proposed. With the introduction of 20 mol% MACl as additives, the fully printed MPSCs are fabricated without any post-treatment at room temperature via one-step drop-coating method. As a consequence, the average power conversion efficiency (PCE) of 14.73 ± 0.3% (0.1 cm²) with almost no hysteresis is achieved. Most importantly, the device also exhibits excellent long-term stability when it is unencapsulated. Specifically, the unencapsulated device still retain nearly 100% of their original PCE after 64 days and retain 88% after 81 days of storage in the dark with a humidity of 50 ± 5% in an atmospheric environment. It provides a new idea for constructing fully printed MPSCs at room temperature in the future.</p><p>This article is protected by copyright. All rights reserved.</p>

energy & fuels,materials science, multidisciplinary