Abstract:The present work is dedicated to the study of multiphase turbulent and three-dimensional rotational flow in dust cyclones, a contribution to air pollution control. Cyclones are widely used devices for the separation of constituents from solid-gas mixtures in industry. In order to improve the filtration efficiency of cyclones, and to reduce the pressure drop, parametric numerical simulation studies using the Fluent code have been conducted to characterise the effects of the parameters affecting the operation of these devices through their performance indicators. In this work, the effect of inlet velocity and the particle size on the turbulent flow air in the cyclone is presented. Numerical simulation of the flow by Fluent code using three numerical models: the first based on the dissipation of kinetic energy by viscosity (RNG) K-epsilon and standard K-epsilon as well as the last based on the solution of Reynolds stress equations (RSM), combined with the multiphase mixing model, gave interesting results in terms of the pressure and flow field in the separator, the variation of inlet velocity, and the variation of particle size. Validation with experimental and empirical results showed the advantage of the Reynolds stress turbulence model (RSM) over the standard K-epsilon and RNG K-epsilon. The RSM model better captures physical phenomena in an intense vortex flow in the presence of walls. But it is characterised by a very long calculation time and requires large machine resources. An alternative to this model is RNG K-epsilon model, which offers a reasonable calculation time with acceptable results (maximum deviation of 5 % ) for speed values below 10 m/s. In the absence of numerical resources, certain empirical models such as those of First (for the evaluation of pressure drop) and Iozia and Leith (for evaluation of efficiency) may well be useful for the dimensioning of the cyclone.

Investigation of erosion in an industrial cyclone preheater by CFD simulations

CFD simulation and experimental validation of multiphase flow in industrial cyclone preheaters

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

Coarse-grained CFD-DEM Simulation of Elbow Erosion Induced by Dilute Gas-Solid Flow: A Multi-Level Study

Micro Gas Cyclone Design and Performance Evaluation to Collect Dust Particles

Numerical Investigation of the Erosion Behavior in Blades of Tidal Current Turbine

Effect of local erosion on the flow field and separation performance of the cyclone separator

Particle-Scale Investigation of Heat Transfer and Erosion Characteristics in a Three-Dimensional Circulating Fluidized Bed

Numerical Study of Solid Particle Erosion in a Cavity with Different Wall Heights

CFD-DDPM coupled with an agglomeration model for simulation of highly loaded large-scale cyclones: Sensitivity analysis of sub-models and model parameters

Investigation of influencing factors of wear in a sandblasting machine by CFD-DEM coupling

Numerical simulation of the erosion in the 90° elbow

CFD Simulation of an Industrial Dust Cyclone Separator: A Comparison with Empirical Models: The Influence of the Inlet Velocity and the Particle Size on Performance Factors in Situation of High Concentration of Particles

Hybrid high-temperature fouling and erosion characteristics of gas-particle flow around heating tube via CFD-DEM

Numerical Investigation of Erosion of Tube Sheet and Tubes of a Shell and Tube Heat Exchanger.

Experimental and computational fluid dynamics study on the effects of erosion spiral angle of the cone on cyclone separator performance

Investigations of Solid Particle Erosion on the Flow Channel Walls of a Radial Turbine for Diesel Engine Applications

A hybrid multiphase model accounting for particle agglomeration for coarse-grid simulation of dense solid flow inside large-scale cyclones

Experimental and numerical study of erosion in a non-Newtonian hydraulic fracturing fluid

Prediction of the performance of dense medium cyclones in coal preparation

Numerical Prediction of Solid Particle Erosion in Jet Pumps Based on a Calibrated Model