Abstract:Environmental barrier coatings (EBCs) enable SiCf/SiC ceramic matrix composites (CMC) to operate under high-temperature combustion conditions. They reduce the oxidation rate of SiC f/SiC, the volatilization of the composites due to reaction with water vapor, and the surface temperature of the composites. Rare-earth monosilicates (RE2SiO5), owing to their excellent high-temperature durability, low thermal conductivity, and good phase stability, are used as the top layer of EBCs. However, they exhibit a high coefficient of thermal expansion (CTE), leading to thermal mismatch and inducing tensile residual stress (with a magnitude of several hundred MPa) in the coating, resulting in the formation of vertical cracks, which act as extremely-high-diffusivity paths for oxidation species transportation and silica volatilization. Therefore, regulating the CTE of RE2SiO5 EBCs and minimizing the CTE mismatch among constituent RE2SiO5 layers with SiC f/SiC CMCs are critical for multilayered EBCs. Through atmospheric plasma spraying, a typical Yb2SiO5/Yb 2Si2O7/Si coating system and a tri-layer structured multicomponent (Y1/4Ho1/4Er1/4Yb1/4)(2)SiO5/Yb2Si2O7/Si coating system with better matched CTEs were manufactured. Both the coatings remained adhered to the substrate during deposition and after annealing, and no mud cracks that would compromise the coating gas-tightness quality and delamination cracks were observed at any of the coating interfaces. In thermal cycling tests, (Y1/4Ho1/4Er1/4Yb1/4)(2)SiO5/Yb2Si2O7/Si coatings showed a lifetime that is three times longer than that of conventional Yb2SiO5/Yb2Si2O7/Si coatings. The failure mechanisms in thermal cycling were investigated via the finite element simulation of stress. It was found that the stress in the substrate was low, and the residual thermal stress was mainly concentrated on the top, inter, and bond layers and increased with an increase in temperature. Compared with that of the (Y1/4Ho1/4Er1/4Yb1/4)(2)SiO5 top coat, the Yb2SiO5 top coat showed obviously higher residual tensile stress, which contributed to a higher tendency for mud-crack formation and higher energy release rate, substantially reducing the coating.. s thermal cycling lifetime. Through neutron powder diffraction and pair distribution function (PDF) analysis, the average and local structures of RE2SiO5 were studied. Overall, the average and local structures did not differ significantly, both of which can be described using the C2/c structure. Nevertheless, the PDF results demonstrated some differences in the disorder degree of Si-O and RE-O coordination environments. In particular, Rietveld refinement results of the PDF showed lower local distortion degree of [ORE4] tetrahedrons when compared with that of the average structure. It is effective to reduce the distortion degree of [ORE4] tetrahedrons by introducing Y3+, Ho3+, and Er3+ into the Yb3+ sites of Yb2SiO5, and smaller distortion degrees lead to lower CTE values. Coordinative local disturbances introduced by strategic high-entropy design have been proposed as the key method for CTE regulation.

Phase Formation Capability and Compositional Design of Β-Phase Multiple Rare-Earth Principal Component Disilicates

Compositional design and phase formation capability of high-entropy rare-earth disilicates from machine learning and decision fusion

Crystallization and Phase Evolution in Novel (gd1/6tb1/6dy1/6tm1/6yb 1/6lu1/6)2si2o7 Environmental Barrier Coating

Accelerating the Design of Multicomponent Rare Earth Silicates for SiCf/SiC CMC by Combinatorial Material Chip Design and High Throughput Screening

Investigation on improving the comprehensive performance of environmental barrier coating materials by high-entropy multiphase design

Promoting the La Solution in 2:14:1-Type Compound: Resultant Chemical Deviation and Microstructural Nanoheterogeneity

Design rules for the thermal and elastic properties of rare-earth disilicates

A Study Of Suppressed Formation Of Low-Conductivity Phases In Doped Li7la3zr2o12 Garnets By In Situ Neutron Diffraction

Designing Orbital and Charge Ordering Multiferroics by Superlattice Strategy and Strain Engineering

First-principles study of the mixing effects of rare earth solute atoms on the physical properties of Al2RE phases in Al-based alloys at finite temperatures

First-principles calculations and thermal-mechanical experimental studies on middle-entropy rare-earth disilicates

Theoretical investigation of formation and diffusion mechanisms for point defects in ytterbium and lutetium silicates

High Entropy Engineering: New Strategy for the Critical Property Optimizations of Rare Earth Silicates

Principal Element Design of Pyrochlore-Fluorite Dual-Phase Medium- and High-Entropy Ceramics

Neutron Pair Distribution Function Analysis to the Local Structure of High-Entropy RE2SiO5 Environmental Barrier Coating

Computational investigation of formation enthalpies and phase stability for rare earth oxyphosphates

Phase purity and evolution in sol–gel derived single component and multicomponent rare‐earth disilicates

Investigation on improving corrosion resistance of rare earth pyrosilicates by high-entropy design with RE-doping

Phase-Transition-Driven Regional Distribution of Rare-Earth Ions for Multiplexed Upconversion Emissions

Towards Thermal Barrier Coating Application for Rare Earth Silicates RE2SiO5 (RE = La, Nd, Sm, Eu, and Gd)

Effects of MgO-RE2O3 and SiO2-RE2O3 (RE = La, Nd, Gd, Ho and Lu) Complex Sintering Additives on the Phase Composition, Microstructure and Mechanical Properties of Dual-Phase Si3N4 Ceramics