Abstract:Two fluorescent high‐performance polymers based on dicyanoarylamine luminogens were readily synthesized via polycondensation. Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive in both solution and solid film states, thereby demonstrating the aggregation‐induced fluorescence changes. Introduction Fluorescent high‐performance polymers have been extensively used in designing optoelectronic devices due to their low cost, excellent thermal stability, high mechanical strength, low flammability, good chemical and radiation resistance, and good electronic properties. While conventional organic luminophores fluoresce strongly in dilute solutions, they suffer from undesirable aggregation‐caused quenching in concentrated solutions and in the solid state due to extensive π‐π stacking interactions and formation of delocalized excitons or excimers. This phenomenon leads to non‐radiative decay thus, decreased fluorescence emission of the material in the solid film state, which significantly limits their real‐world application as solid light‐emitting materials. Objectives To develop new high‐performance polymers with high photo luminescent efficiency, good processability, film‐forming properties, which could potentially be used in the fabrication of optoelectronic devices. Methods The preparation of the polyimide DiCN‐PI was carried out by a one‐step, high‐temperature solution imidization method. In this procedure, 1,2,4,5‐cyclohexanetetracarboxylic dianhydride and the diamine were polymerized in 1‐methyl‐2‐pyrrolidinone and γ‐butyrolactone co‐solvent at 180°C for 15 hours in the presence of isoquinoline as catalyst. On the other hand, polyamide DiCN‐PA was synthesized according to the direct phosphorylation polycondensation technique described by Yamazaki from diamine and trans‐1,4‐cyclohexanedicarboxylic acid using triphenyl phosphite and pyridine as condensing agents. Results and Discussion Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive with PL emission bands around 555 (bluish‐green) and 498 (cyan) nm in dilute 1‐methyl‐2‐pyrrolidinone solutions for polyimide and polyamide, respectively. In the solid film state, the polymers emit light green and yellow colors, which simulate the PL behavior of their aggregated states, thereby demonstrating aggregation‐induced fluorescence changes. Conclusions These results indicate that the incorporation of bulky dicyanoarylamine moiety and alicyclic monomer units into the rigid polymer backbones effectively disrupted the planarity of the chain packing which resulted to the fluorescent high‐performance polymers with desired properties for potential optoelectronic applications.

Nonaromatic Polymaleimides with Full-Color Photoluminescence

Anionic polymerization of nonaromatic maleimide to achieve full-color nonconventional luminescence

Luminescent and light refractive polymers: Synthesis and optical and photonic properties of poly(arylene ethynylene)s carrying silole and tetraphenylethene luminogenic units

Significantly Red-Shifted Emissions of Nonconventional AIE Polymers Containing Zwitterionic Components

Enabling nonconjugated polyesters emit full-spectrum fluorescence from blue to near-infrared

A Novel Triarylamine-Based Conjugated Polymer and Its Unusual Light-Emitting Properties

Phosphine-Capped Effects Enable Full-Color Clusteroluminescence in Nonconjugated Polyesters.

Unique photoluminescence from nonconjugated alternating copolymer poly[(maleic anhydride)-alt-(vinyl acetate)]

Reversible, photoresponsive, dynamic wide-range emission color from polymer-matrixed naphthalene diimide single-luminogen

Twisted D–π–A Solid Emitters: Efficient Emission and High Contrast Mechanochromism

Photoluminescent nanoparticles in water with tunable emission for coating and ink-jet printing

D–A Solid Emitter with Crowded and Remarkably Twisted Conformations Exhibiting Multifunctionality and Multicolor Mechanochromism

Hydrated Hydroxide Complex Dominates the AIE Properties of Nonconjugated Polymeric Luminophores

Achieving Swift and Distinct Luminescent Modulation Through Manipulating Molecular Motion in Polymers

Molecular Engineering of Colorless Triphenylamine-Based Polymers for Multicolor Electrochromism and Energy Storage

Polymeric Metal Halides with Bright Luminescence and Versatile Processability

Catalyst-Free Multicomponent Tandem Polymerizations of Alkyne and Amines toward Nontraditional Intrinsic Luminescent Poly(aminomaleimide)s

Synthesis, characterization, and photophysical properties of dicyanoarylamine‐based semi‐aromatic polymers

Ultrabright Acrylic Polymers with Tunable Fluorescence Enabled by Imprisoning Single TICT Probe

Tunable Photoresponsive Behaviors Based on Triphenylamine Derivatives: The Pivotal Role of π‐Conjugated Structure and Corresponding Application

Room temperature phosphorescence, thermally activated delayed fluorescence and multicolor mechanochromic luminescence of emitters through molecular interaction and conformational modulations