Complex function stress solution of cold region tunnels under frictional contact condition of lining and surrounding rock with support delay
Zhitao Lv,Mengxiang Yan,Shiqing Yuan,Caichu Xia,Xiangtai Zeng
DOI: https://doi.org/10.1016/j.apm.2024.115817
IF: 5.336
2024-11-20
Applied Mathematical Modelling
Abstract:Previous stress solutions for cold region tunnels (CRT) are basically based on the assumption of full bond contact between the lining and surrounding rock (SR). Whereas, in actual engineering practices, the lining and SR are in frictional contact condition. Based on the complex variable function theory and optimization method, the stress solution of CRT is established under the frictional contact condition of lining and SR, and the solution considers the transversely isotropic frost heave deformation of SR and the support delay. The Coulomb friction law is applied to describe the frictional contact between SR and lining, and the frictional contact condition is solved by the optimization method regarding the state of lining with the least relative sliding amount on the contact surface as its real working state. The stress solution is validated with numerical simulation. The stress distributions of lining and SR under three contact conditions, namely, the full bond contact condition, the full slip contact condition and frictional contact condition, are analyzed and compared. Results show that when the frictional coefficient f r take the values of 1.0 and 0.0 under the frictional contact condition, the stress distributions solved by the optimization method are consistent with the results directly derived from solutions under the full bond and full slip contact conditions, respectively. This illustrates the validity of the optimization method in solving the frictional contact condition. Under these three contact conditions, the radial stresses of lining and frozen SR increase with radius while the circumferential stresses decrease with radius, and the influence of frictional contact condition on circumferential stresses in lining and frozen SR is more significant. Under different frictional coefficients, the radial contact stress at the lining and SR interface decreases with increasing angle, and the radial stress at 45° keeps as a constant. When the frictional coefficient f r increases, the tangential contact stress at the interface increases. Besides, the tangential stress and relative displacement at the contact surface are always maximum at 45°.
mechanics,engineering, multidisciplinary,mathematics, interdisciplinary applications