A Study on the Borehole Wall Stability Analysis and Slurry Ratio Optimization for Construction of Pile in Complex Marine Strata
Qingxiong Zhao,Linglin Xie,Ping Cao,Ziyang Zhang,Kaihui Li,Hang Lin,Chao Huang
DOI: https://doi.org/10.3390/ma17091984
IF: 3.4
2024-04-25
Materials
Abstract:In order to address the issue of hole collapse, which frequently arises when boring piles are being constructed in intricate marine strata, this paper discusses the influence of the slurry ratio on the slurry performance as well as the mechanism of slurry wall protection. It performs this by means of theoretical analysis, laboratory ratio testing, engineering analogies, numerical simulation, and field testing. Our findings demonstrate that adding sodium polyacrylate and sodium carboxymethyl cellulose can enhance mud's viscosity, contribute to flocculation, and improve the connection between mud and soil layers. Refering similar engineering cases, three optimization schemes are proposed for achieving a mud ratio that offers wall protection in complex marine strata. Furthermore, the particle flow model of slurry viscous fluid is established. The collapse of holes in the sand layer is reflected in the uneven radial displacement of hole walls and the invasion of mud particles. Increasing the viscosity of mud gradually transforms the uneven radial deformation of pore walls in the sand layer into a uniform radial deformation, whereas increasing the proportion of mud significantly decreases the radial displacement of hole walls. Additionally, when the mud pressure in the hole is 300 kPa and 600 kPa, the wall protection effect is better, and there is no particle penetration by substances such as sand. It is found that a high mud pressure can promote the diffusion of mud particles into the sand layer, while low mud pressure cannot balance the pressure on deep soil. The results of the field tests show that the ratio of water–clay–bentonite–CMC-Na–sodium carbonate = 700:110:90:1.5:0.5 used (where the mass percentage of each material is 77.8% water, 12.2% clay, 10% bentonite, 0.16% CMC-Na, and 0.05% sodium carbonate) can effectively prevent hole collapse and reduce the thickness of the sand layer at the bottom of the hole by 50%.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering